Sunflower Seed Husk As Green Agro-waste Filler For EPDM Rubber | ||||
| Egyptian Journal of Chemistry | ||||
| Article 44, Volume 64, Issue 10, October 2021, Page 5853-5861 PDF (841.73 K) | ||||
| Document Type: Original Article | ||||
| DOI: 10.21608/ejchem.2021.71142.3562 | ||||
 View on SCiNiTO | ||||
| Authors | ||||
Abeer S reffaee   1; Doaa Essamey El-Nashar 2; Attia A Yaseen3; Salwa L Abd-El-Messieh4
| ||||
| 1Dielectric, National Research Cenre | ||||
| 2Polymers and Pigments Department, National Research Centre, Dokki, Cairo, Egypt | ||||
| 3Food Technology Dept., National Research Centre | ||||
| 4Microwave Physics and Dielectrics Department, National Research Centre, Cairo, Egypt | ||||
| Abstract | ||||
| Sunflower seed Husk (SSH) was used as green agro waste filler for EPDM matrix. Two particle sizes of SSH were used (91.8 µm and 7.5 µm). Chemical composition of SSH was investigated. The permittivity and dielectric loss were measured over a frequency range 10-1 up to 106 Hz for EPDM/WPS with two different particle sizes. Both values were found to increase by increasing SSH content. The curves relating dielectric loss and the applied frequency were analyzed into three relaxation processes and the obtained relaxations were interpreted. The dc conductivity was found to be in the order 10-15 S cm-1 which recommend such composites to be used in insulatation purposes.Mechanical properties including tensile strength at break (σR) and elongation at break (εR) were found to decrease by increasing filler content. | ||||
| Keywords | ||||
| permittivity; polymer composites; thermal stability; sunflower seed husk | ||||
|
Statistics Article View: 505 PDF Download: 383 |
||||
