Effect of margin design of Monolithic Multilayered zirconia Crowns on Internal & Marginal Fit | ||
| Ain Shams Dental Journal | ||
| Article 8, Volume 21, Issue 1, March 2021, Pages 49-58 | ||
| Document Type: Original articles | ||
| DOI: 10.21608/asdj.2021.62647.1025 | ||
| Authors | ||
| Sara Mostafa Abd Elmgeed* 1; Marwa Wahsh2; Ghada Abd Elsattar3 | ||
| 1Fixed Prosthodontics Department, Faculty of Dentistry Ahram Canadian University , Cairo, Egypt | ||
| 2Fixed Prosthodontics Department, Faculty of Dentistry, Ain Shams University, Cairo , ,Egypt | ||
| 3Fixed prosthodontics Department, Faculty of Dentistry, Ain Shams University , Cairo ,Egypt | ||
| Abstract | ||
| Aim: The present study was performed to evaluate the effect of preparation design on the internal and marginal fit of monolithic multilayered super translucent zirconia crowns. Methodology: Two typodont teeth (mandibular second molar) were prepared to receive full coverage restorations using two designs: Horizontal finish line (chamfer) and vertical (feather edge) preparations. Twenty resin epoxy dies were duplicated, ten from each typodont tooth. Twenty Multi-layered super translucent zirconia (Katana STML, Kuraray Noritake) crowns were constructed with a CAD/CAM system. All the finished crowns were cemented to their corresponding dies then each sample was vertically sectioned bucco-lingually into 2 sections. Marginal, axial and occlusal gaps were measured at eight defined points on each section using stereomicroscope. Results: The significance level was set at P Conclusion: the mean marginal and internal gaps varied significantly by the preparation designs, showing better marginal adaptability with chamfer group but still both groups were within the clinically acceptable range. Keywords: All Ceramic-Monolithic Zirconia-Marginal Fit-Internal Fit. | ||
| Keywords | ||
| All Ceramic; Monolithic Zirconia; Marginal Fit; Internal Fit | ||
|
Statistics Article View: 422 |
||
