Optimization Of Cutting Parameters On Surface Roughness And Material Removal Rate Using Response Surface Methodology In Turning Process Of Al- 7075 With High Speed Steel | ||
| Engineering Research Journal (Shoubra) | ||
| Volume 42, Issue 1, October 2019, Pages 15-22 PDF (1.63 M) | ||
| Document Type: Research articles | ||
| DOI: 10.21608/erjsh.2019.242407 | ||
| Authors | ||
| Gilan Eid Ramadan1; Naser aldin Ahmed Ibrahim1; Sayed Abd ELwanis abd allah2 | ||
| 1Mechanical engineering department, Modern Academy | ||
| 2Mechanical engineering department ,Shoubra faculty of engineering ,Benha university | ||
| Abstract | ||
| This work presents an experimental study to optimize the effect of cutting condition (cutting speed N& feed f& depth of cut) on surface roughness SR (Centre line average roughness (Ra)&Root mean square roughness (Rq)) and material removal rate MRR. Al-7075 workpiece is the experimental material on turning process with HSS. Response surface methodology is the statistical technique used for modelling and analysing. Feed is the most effective parameter on SR. However, MRR has two effective parameters, cutting speed, feed rate. | ||
| Keywords | ||
| surface Roughness; Turning; Response Surface Methodology; cutting conditions | ||
|
Statistics Article View: 143 PDF Download: 174 |
||
