Investigation of Thermal-Hydraulic Behavior of Supercritical Water Reactor Using Thorium-Uranium Oxide Fuel (ThO2 – UO2) | ||||
| Arab Journal of Nuclear Sciences and Applications | ||||
| Article 6, Volume 52, Issue 2, April 2019, Page 35-44 PDF (627.5 K) | ||||
| Document Type: Original Article | ||||
| DOI: 10.21608/ajnsa.2019.4062.1094 | ||||
 View on SCiNiTO | ||||
| Authors | ||||
salwa helmy  1; Adel Fahmy2; Adel El-Feky2; Neama El-Sahlamy1; Hesham Hasaneen Elkhatib3
| ||||
| 1Nuclear and Radiological Regulatory Authority (NRRA), Cairo, Egypt | ||||
| 2Reactors Department, Nuclear ResearchCenter, Atomic Energy Authority, P.O.13759, Cairo, Egypt | ||||
| 3bNuclear reactors department, NRC Center, Egyptian Atomic Energy Authority | ||||
| Abstract | ||||
| A computer program by (EES), Engineering Equation Solver has been produced for inquiry of the fuel, clad and coolant temperatures under supercritical conditions for supercritical water reactor powered by ThO2 – UO2 mixture as a fuel. In the calculation, uniform axial heat flux and average channel were considered. The bulk fluid, clad and fuel temperatures along fuel length were obtained for supercritical pressures 26, 30 and 40 (MPa). Also the UO2 percentage added to ThO2 was varied as, 4% and 10%. It was found that the maximum fuel temperature reached 2193 (oC) in case of 4% UO2 and 2182 (oC) in case of 10% UO2, which is surpasses the industry limit of 1850 (OC).Thermal conductivity is essential parameterto understand the performance of the fuel pin under irradiation.Other important thermo-physical properties to be considered are melting point and density.Thorium and uranium oxide fuels utilized in nuclear reactors have very high melting point, but low density and they suffer from poor thermal conductivity | ||||
| Keywords | ||||
| Key Words -(Th; U)O2 pellets; thermal conductivity; thermal hydraulic; supercritical | ||||
|
Statistics Article View: 376 PDF Download: 420 |
||||
