The assessment of the precision (marginal and internal) of 3D printing and milled interim crowns.
Radwan, M., shabaan, A., Mahrous, A. (2023). The assessment of the precision (marginal and internal) of 3D printing and milled interim crowns.. EKB Journal Management System, 69(1), 603-610. doi: 10.21608/edj.2023.170516.2319
Mohamed Radwan; Alshaimaa shabaan; Aliaa Mahrous. "The assessment of the precision (marginal and internal) of 3D printing and milled interim crowns.". EKB Journal Management System, 69, 1, 2023, 603-610. doi: 10.21608/edj.2023.170516.2319
Radwan, M., shabaan, A., Mahrous, A. (2023). 'The assessment of the precision (marginal and internal) of 3D printing and milled interim crowns.', EKB Journal Management System, 69(1), pp. 603-610. doi: 10.21608/edj.2023.170516.2319
Radwan, M., shabaan, A., Mahrous, A. The assessment of the precision (marginal and internal) of 3D printing and milled interim crowns.. EKB Journal Management System, 2023; 69(1): 603-610. doi: 10.21608/edj.2023.170516.2319

The assessment of the precision (marginal and internal) of 3D printing and milled interim crowns.

Egyptian Dental Journal
Article 16, Volume 69, Issue 1 - Serial Number 4, January 2023, Page 603-610  XML PDF (922.88 K)
Document Type: Original Article
DOI: 10.21608/edj.2023.170516.2319
View on SCiNiTO View on SCiNiTO
Authors
Mohamed Radwan email orcid 1; Alshaimaa shabaanorcid 2; Aliaa Mahrousorcid 3
1Lecturer, Fixed Prosthodontics Department, Faculty of Dentistry, Beni-Suef University
2Assistant Professor, Oral Maxillofacial Surgery Department, Faculty of Dentistry Fayoum University
3Assistant Professor, Fixed Prosthodontics Department, Faculty of Dentistry, Fayoum University
Abstract
OBJECTIVE: This study aims to assess the precision (marginal and internal) of 3D printing and milled interim crowns.
METHODS: a study model of all ceramic preparation for the maxillary first molar was fabricated. Interim crowns were fabricated using milling systems (imes-icore 250i , n = 10 ) and 3D printing ( Rapidshape D30 , n = 10 ).The marginal misfit and Internal gap were assesed using the replica technique. All the achieved data was analyzed with Shapiro-wilk’s test which was followed by independent t-test.
Results: The smallest discrepancy of 63.30±13.27 μm was observed in marginal misfit of the Printing group followed by milled group with the gap of 121.94±1.53 μm. The marginal misfit and internal gap showed a significant difference between the two groups, it has been observed that the 3D Printing technology has the capability to fabricate an interim crown with better precision fit than milling one.
CONCLUSIONS: Interim crowns that is constructed by 3D printing technology have better precision ( marginal and internal ) compared to milled one.
Keywords
3D printing; Milling; Interim; marginal; internal gap
Statistics
Article View: 332
PDF Download: 260