Effect of Back Pressure and Divergence Angle on Location of Normal Shock Wave | ||||
| Journal of Measurement Science and Applications (JMSA) | ||||
| Volume 3, Issue 2, August 2023, Page 15-31 PDF (2.1 MB) | ||||
| Document Type: Original Article | ||||
| DOI: 10.21608/jmsa.2023.318495 | ||||
 View on SCiNiTO | ||||
| Authors | ||||
Fatma A-M Kassem  1; R. A. Shaalan Mohamed2; Riham Hegazy3; A. A. Saeed2
| ||||
| 1Volume and Fluid Flow Metrology Lab., National Institute of Standards (NIS). Giza, Egypt | ||||
| 2Mechanical Power Engineering, Faculty of Engineering, Zagazig University | ||||
| 3Force and Material Metrology Laboratory., National Institute of Standards (NIS) Giza. Egypt | ||||
| Abstract | ||||
| This paper presents a study of the effect of back pressure variation on the mass flow rate and normal shock occurrence in a sonic nozzle. ANSYS-FLUENT software was used for numerical simulation, and experimental measurements were carried out to verify the numerical results. Nozzles of various designs (different divergence angles and throat diameters) were subjected to investigation. The simulation results indicate that both the divergence angle and the throat diameter markedly influence the performance via the occurrence of normal shock in the divergent part of the nozzle. The nozzle throat diameter ranges from 0.558 to 3.175 mm, and the back-pressure ratio is 0.6. Normal shocks move toward the nozzle exit upon a decrease in divergence angle and an increase in throat diameter. For this diameter range, the corresponding distance from the nozzle inlet toward the divergent section at which a normal shock occurs is 2.8 to 3.2. | ||||
| Keywords | ||||
| Sonic nozzle; Divergent angle; Normal-shock wave; Reynolds number; Back pressure ratio | ||||
|
Statistics Article View: 180 PDF Download: 154 |
||||
