COMBINED MECHANIZATION SYSTEM'S POWER QUIREMENTS FOR COTTON CROP (SEED-BED PREPARATION AND PLANTING) | ||||
| Egyptian Journal of Agricultural Research | ||||
| Article 35, Volume 77, Issue 1, March 1999, Page 465-484 PDF (4.22 MB) | ||||
| Document Type: Original Article | ||||
| DOI: 10.21608/ejar.1999.326685 | ||||
 View on SCiNiTO | ||||
| Author | ||||
| METWALLI E. M. METWALLI | ||||
| Agricultural Engineering Research institute, Agricultural Research Center, Dokki, Egypt | ||||
| Abstract | ||||
| Combined mechanization systems of primary tillage (plows) and planting methods (manual and mechanical) for cotton crop were studied on clayey soil. Strain gage instrumentation, as a measuring technique, was used to measure the pull force and the torque at left and right rear wheels of tractor for cotton seed-bed preparation. Also, the penetration force was measured before and after tillage operations and soil clods were measured after tillage. In addition, the yield was determined at picking times where the picking was manual. Statistical analyses of these data showed that the best combinations were "moldboard plow at 5km/h + manual planting "," chisel plow at 5 km/h + manual planting "," chisel plow at 5 km/h + planter "and "chisel plow at 4 km/h + planter respectively. Also, the torque ratio between left and right wheels was unity with chisel plow and eight times with moldboard plow. The power ratio between rear wheels axis and drawbar was equal to two with chisel plow and four with moldboard plow. | ||||
|
Statistics Article View: 67 PDF Download: 224 |
||||
