Flexural Behavior of Beams Fabricated Using Light Gauge Steel with Rectangular or Triangular Hollow Flanges
Sharaf, T., Elsabbagh, A., Abdellatif, M., Elghandour, M. (2019). Flexural Behavior of Beams Fabricated Using Light Gauge Steel with Rectangular or Triangular Hollow Flanges. EKB Journal Management System, 23(1), 47-64. doi: 10.21608/pserj.2019.32833
Tarek Sharaf; Ashraf Elsabbagh; Mohamed Abdellatif; Mohamed Elghandour. "Flexural Behavior of Beams Fabricated Using Light Gauge Steel with Rectangular or Triangular Hollow Flanges". EKB Journal Management System, 23, 1, 2019, 47-64. doi: 10.21608/pserj.2019.32833
Sharaf, T., Elsabbagh, A., Abdellatif, M., Elghandour, M. (2019). 'Flexural Behavior of Beams Fabricated Using Light Gauge Steel with Rectangular or Triangular Hollow Flanges', EKB Journal Management System, 23(1), pp. 47-64. doi: 10.21608/pserj.2019.32833
Sharaf, T., Elsabbagh, A., Abdellatif, M., Elghandour, M. Flexural Behavior of Beams Fabricated Using Light Gauge Steel with Rectangular or Triangular Hollow Flanges. EKB Journal Management System, 2019; 23(1): 47-64. doi: 10.21608/pserj.2019.32833

Flexural Behavior of Beams Fabricated Using Light Gauge Steel with Rectangular or Triangular Hollow Flanges

Port-Said Engineering Research Journal
Article 6, Volume 23, Issue 1 - Serial Number 1110, March 2019, Page 47-64  XML PDF (1.83 MB)
Document Type: Original Article
DOI: 10.21608/pserj.2019.32833
View on SCiNiTO View on SCiNiTO
Authors
Tarek Sharaf1; Ashraf Elsabbagh email 2; Mohamed Abdellatif3; Mohamed Elghandour3
1Department of civil Engineering, Faculty of Engineering , Port Said University
2Civil Engineering Department,Faculty of Engineering, Port Said University
3Faculty of Engineering, Civil Engineering Department, Port Said University
Abstract
Although the hot-rolled steel members have been considered as the most common and widely used steel profiles, but light gauge steel (LGS) use in structures is widely increasing recently. The structural attitude of this light gauge is characterized by different buckling modes as local, distortional, and torsional buckling. Light gauge steel sections are being produced in many forms. One of these forms is the hollow flanged beam sections which proved its effectiveness but their behavior still not fully understood. In this paper, the moment behavior of LGS beams is verified using the finite element analysis. A numerical study was applied to figure out the parameters affecting the behavior of the LGS beams in case of using hollow flanges, either rectangular or triangular, with and without vertical stiffening under flexural loading. All beams were simply supported and subjected to two-point loadings configuration. The ultimate load capacity and failure mode of all beams were determined. Three different design codes were utilized to validate the results.
Keywords
Rectangular hollow flange steel beams; Triangular hollow flange steel beams; Finite Element Analysis; Light gauge steel; Design standards; Local buckling failure
Statistics
Article View: 411
PDF Download: 653