EVALUATION OF MICROBIOLOGICAL PARAMETERS OF HACCP SYSTEM IN A JUICE PRODUCTION LINE IN LOCAL COMPANY
Azab, M., Emara, M., Azab, M., Fouda, A., Radwan, A., Emara, M., Ebeid, A. (2018). EVALUATION OF MICROBIOLOGICAL PARAMETERS OF HACCP SYSTEM IN A JUICE PRODUCTION LINE IN LOCAL COMPANY. EKB Journal Management System, 2018(6), 29-42. doi: 10.21608/absb.2018.33756
M. Azab; M. Emara; M. Azab; A. M. Fouda; A. A. Radwan; M. B. Emara; A. A. Ebeid. "EVALUATION OF MICROBIOLOGICAL PARAMETERS OF HACCP SYSTEM IN A JUICE PRODUCTION LINE IN LOCAL COMPANY". EKB Journal Management System, 2018, 6, 2018, 29-42. doi: 10.21608/absb.2018.33756
Azab, M., Emara, M., Azab, M., Fouda, A., Radwan, A., Emara, M., Ebeid, A. (2018). 'EVALUATION OF MICROBIOLOGICAL PARAMETERS OF HACCP SYSTEM IN A JUICE PRODUCTION LINE IN LOCAL COMPANY', EKB Journal Management System, 2018(6), pp. 29-42. doi: 10.21608/absb.2018.33756
Azab, M., Emara, M., Azab, M., Fouda, A., Radwan, A., Emara, M., Ebeid, A. EVALUATION OF MICROBIOLOGICAL PARAMETERS OF HACCP SYSTEM IN A JUICE PRODUCTION LINE IN LOCAL COMPANY. EKB Journal Management System, 2018; 2018(6): 29-42. doi: 10.21608/absb.2018.33756

EVALUATION OF MICROBIOLOGICAL PARAMETERS OF HACCP SYSTEM IN A JUICE PRODUCTION LINE IN LOCAL COMPANY

Al-Azhar Bulletin of Science
Article 11, Volume 2018, Issue 6, June 2018, Page 29-42  XML PDF (730.06 K)
Document Type: Original Article
DOI: 10.21608/absb.2018.33756
View on SCiNiTO View on SCiNiTO
Authors
M. Azab1; M. Emara2; M. Azab* 1; A. M. Fouda1; A. A. Radwan1; M. B. Emara2; A. A. Ebeid3
1Botany and Microbiology Department, Faculty of Science (Boys), Al-Azhar University, Cairo, Egypt
2Food safety and hygiene advisor, Quality unit, Ministry of Tourism
3Lab and quality supervisor at food and juice industry
Abstract
This study was conducted to assess the Hazard Analysis and Critical Control Point (HACCP) system in a pasteurized juice production line through follow up prerequisite programs (PrP), Good Manufacturing Practices (GMP) and Critical Control Points (CCPs), the results were then compared to the standard specification. A total numbers of 361 samples were collected from the production line in local company including fruit concentrates, water, food contact surfaces, personnel swabs, environmental air and finished products samples. Standard methods were used to determine Total Plate Count (TPC), yeasts, moulds, coliform, heat resistant moulds and acid tolerant bacteria (Alicyclobacillus). Most of investigated samples were out of the standard acceptable ranges. The percentages of TPC, yeast and moulds in samples collected from fruit concentrates, food contact surfaces, water samples, personnel swabs, environmental air and finished products were significantly non-confirmed (22%, 85%, 41%, 44%, 14% and 4%), respectively. All these parameters counts lead to contamination in the products and cause high cost as a result of scraping these contaminated products. This was the first stage of problem evaluation and determining the CCP in order to overcome or reduce the phenomenon of microbial pollution in finished products.
Keywords
HACCP system; GMP; Juice microbiology and Evaluation
Statistics
Article View: 472
PDF Download: 1,222