CHARACTERIZATION AND TENSILE STRENGTH EVALUATION OF CHITOSAN SCAFFOLDS INCORPORATED WITH GRAPHENE OXIDE NANOPARTICLES (IN-VITRO STUDY) | ||||
| Alexandria Dental Journal | ||||
| Article 5, Volume 49, Issue 3, December 2024, Page 128-134 PDF (384.77 K) | ||||
| Document Type: Original Article | ||||
| DOI: 10.21608/adjalexu.2023.222527.1396 | ||||
 View on SCiNiTO | ||||
| Authors | ||||
asmaa M ali  1; Sonia morsy Elshabrawy2; Elbadawy Abdelaziz Kamoun3
| ||||
| 1kafr elsheikh university | ||||
| 2Dental Biomaterials Department, Faculty of Dentistry, Alexandria University, Alexandria, Egypt | ||||
| 3Polymeric Materials Research Department, City of Scientific Research and Technological Applications, Alexandria, Egypt Nanotechnology Research Center (NTRC), The British University in Egypt, Cairo, Egypt. | ||||
| Abstract | ||||
| ABSTRACT Introduction: Chitosan (CTS) has been a popular option for scaffold fabrication because of its biocompatibility, biodegradability, antimicrobial and nonimmunogenic effects. However, it is of limited function, due to its low mechanical strength and its solubility in acidified media. These limitations could be overcome by its blending with other polymers like polyvinyl alcohol (PVA) and incorporation of other bioactive material such as carbon-based nanomaterials like graphene oxide (GO) to improve its mechanical properties and tissue regeneration capability. Objective: Evaluation of the tensile strength of CTS-PVA-GO nanocomposites with different ratios of scaffold composition of CTS and GO Methods: GO nanoparticles were chemically prepared and characterized. Different concentrations of both CTS and nano-GO were used for fabrication of CTS/PVA/GO nanocomposite films through the solvent casting method. Tensile strength of the nanocomposite films was assessed after characterization by FTIR and SEM. Results: Groups were compared using Kruskal Wallis test followed by Dunn’s post hoc test. There was no significant difference in tensile strength between the nanocomposite films of CTS (2%) and CTS (3%). The tensile strength decreased after addition of nano-GO at different concentrations. Conclusions: Obtaining the best mechanical properties of CTS/PVA/GO nanocomposite scaffold for dental hard tissue engineering requires low concentrations of CTS (less than 2%) without increasing the GO concentration above 1% to prevent its aggregation. | ||||
| Keywords | ||||
| Keywords: Chitosan; Polyvinyl alcohol; Graphene oxide nanoparticles Tensile strength | ||||
|
Statistics Article View: 205 PDF Download: 248 |
||||
