Effect of Shroud Components on the Performance of a Small Horizontal Axis Wind Turbine | ||||
| Journal of Advanced Engineering Trends | ||||
| Volume 43, Issue 2, July 2024, Page 219-227 PDF (777.73 K) | ||||
| Document Type: Original Article | ||||
| DOI: 10.21608/jaet.2023.195584.1240 | ||||
 View on SCiNiTO | ||||
| Authors | ||||
Gamal R. H. Abo Elyamin   1; Magdy A. Bassily2
| ||||
| 1Department of Mechanical Power Engineering- Faculty of Engineering - Minia University - Mina - Egypt | ||||
| 2Department of Mechanical Power Engineering-Faculty of Engineering-Minia University-Minia-Egypt | ||||
| Abstract | ||||
| A small horizontal axis wind turbine has been tested experimentally to show the influence of shroud components on the turbine's overall performance. The reference case was the bare wind turbine. The different parts of the shroud are connecting ring, inducer, diffuser, and lens. The maximum power coefficient (Cp) of the used bare HAWT is 0.1969 (1st case). When the connecting ring was attached to the reference case (2nd case), the maximum Cp decreased to 0.1695. In the (3rd case) an inducer is attached to the connecting ring, maximum Cp increased to 0.2213, about 11% higher than the bare wind turbine. When adding a diffuser part to the inducer and the connecting ring (4th case), the performance increased to 0.347, which is improved by 36.2% compared to the third case and 43.26% to a bare wind turbine. In the (5th case) a lens was added to the diffuser outlet to construct a full shroud. For this construction, the best performance is obtained at Cp of 0.35. This case improved the performance by 43.74%, more than the bare turbine. To reduce the construction cost, in the (6th case), the inlet inducer is removed and the connecting ring with flanged diffuser assembly is examined, under the same working condition, the performance is reduced to 0.308. Although the performance, in this case, was lower than the case of a full shroud, it improved the performance over the bare turbine and the case of inducer-connecting ring assembly by 36.07% and 44.97% respectively. | ||||
| Keywords | ||||
| Diffuser-augmented wind turbine; Renewable energy; Shrouded wind turbine; Small horizontal axis wind turbine | ||||
|
Supplementary Files
|
||||
|
Statistics Article View: 211 PDF Download: 173 |
||||
