Experimental and statistical optimisation of Nd-YAG crystal laser cutting process of INCONEL-718 using grey relational analysis. | ||||
Journal of Engineering Science and Military Technologies | ||||
Volume 9, Issue 1, March 2025, Page 23-32 PDF (1.25 MB) | ||||
Document Type: Original Article | ||||
DOI: 10.21608/ejmtc.2024.242645.1266 | ||||
![]() | ||||
Authors | ||||
Amro M Youssef ![]() ![]() | ||||
1High Institute for engineering and technology Alobour | ||||
2Egyptian Ministry of defense | ||||
3Manufacturing Technology Division, Central Metallurgical R & D Institute (CMRDI), Ministry of Scientific Research, | ||||
4Higher Colleges of Technology (HCT), Abu Dhabi, UAE | ||||
Abstract | ||||
Ιnconel-718 is one of widely utilized Ni-based superalloysforaerospace enginesapplications. This is due to the superior thermos-mechanical properties and high temperature oxidation resistance.This paper aims to achieve optimal parameterswhile cutting thin sheet of Inconel- 718employed pulsed Νd-YAG laser. The Taguchi method will be used to reduce the variation in the process.The overall objective of this work is to obtain trustable optimal cutting parameters by performing smaller numberof experiments aiming to reduce the cost. Κerf width, perpendicularity and number of striations are the parameters under investigation. Ԍrey relational analysis (ԌRΑ), is utilised to reach the optimal cutting process parameters.These parameters are traverse feed velocity 350 mm/min, pulse height 80%, pulse duration 1 ms. and pulse frequency 50Hz .Experimental verifications show a good agreement concerning the predicted and the actual cutting process quality measures at the optimal cutting parameters | ||||
Keywords | ||||
Cutting process optimisation; grey relation analysis; inconel-718 cutting; Laser cutting | ||||
Statistics Article View: 163 PDF Download: 43 |
||||