Passive Cooling of Multijunction Concentrator Photovoltaic Solar Cells | ||
| Engineering Research Journal (Shoubra) | ||
| Volume 45, Issue 1, July 2020, Pages 62-67 PDF (634.5 K) | ||
| Document Type: Research articles | ||
| DOI: 10.21608/erjsh.2020.405603 | ||
| Authors | ||
| H. Zaghloul; M. Emam; M. A. Abdelrahman; M. Fayek | ||
| Department of Mechanical Engineering, Benha University, Egypt | ||
| Abstract | ||
| solar concentrator photovoltaic (cpv) is a potential solution to provide renewable energy at higher efficiency and less cost. the elevated temperature of the solar cells due to the accumulated heat leads to a decrease in the electricity generation efficiency of the solar cell. the current study aims to enhance the multijunction (mj) solar cell electrical conversion efficiency using a passive cooling technique. three configurations of mj solar cell modules as follows, a mj solar cell module without any heat sink, a mj solar cell module with flat plate fin and a mj solar cell module with straight fins attached to a flat plate base were simulated using acfd software. the effects of the ambient temperature have been studied under the constant solar concentration of 50 suns and wind speed of 1 m/s.the results showed that using a heat sink decreases the maximum solar cell temperature by 43.9% and 50.68% and consequently increases the solar cell efficiency by 4.08% and 4.68% in case of flat plate fin and straight fins attached to a flat plate base respectively compared to the solar cell without any heat sink. | ||
| Keywords | ||
| multijunction solar cells; concentrator photovoltaic; heat sink; straight fins; flat plate fin | ||
|
Statistics Article View: 117 PDF Download: 52 |
||
