Analysis and control of primary resonance in an oscillatory cantilever beam excited transversely at its free end | ||||
| Menoufia Journal of Electronic Engineering Research | ||||
| Articles in Press, Accepted Manuscript, Available Online from 01 July 2025 PDF (1.6 MB) | ||||
| Document Type: Original Article | ||||
| DOI: 10.21608/mjeer.2025.341820.1100 | ||||
 View on SCiNiTO | ||||
| Authors | ||||
Eman Desoky Mohamed  1; Ali Kandil 2; magdi kamel3
| ||||
| 1Electronics and Electrical Communications Engineering, Faculty of Electronic Engineering, Menoufia University, | ||||
| 2Department of Applied and Computational Mathematics, Institute of Basic and Applied Sciences, Egypt-Japan University of Science and Technology (E-JUST), New Borg El-Arab City, 21934, Alexandria, Egypt | ||||
| 3Department of Physics and Engineering Mathematics, Faculty of Electronic Engineering, Menouf, 32952, Menoufia University, Egypt | ||||
| Abstract | ||||
| Abstract—In this paper, an oscillatory cantilever beam that is excited transversely at its free end is studied. This type of excitation causes the appearance of external and parametric forces that enhance the unwanted nonlinear vibrations of the beam especially at resonance cases. This dynamical behavior is modeled in a nonlinear differential equation to be solved analytically and numerically in an approximate sense. In addition, positive position feedback (PPF) control algorithm is applied through piezoelectric actuators implemented all over the beam’s surface in order to reduce such vibrations. Furthermore, the simultaneous primary and internal resonance case is investigated to see how the control law can overcome it. The beam’s overall characteristics are pictured with the aid of the multiple scales method in order to judge the effectiveness of the controller. Accordingly, the steady-state behavior’s stability is tested applying Lyapunov’s first (indirect) method along with Routh-Hurwitz criterion. The bifurcation analysis of the cantilever beam is shown before and after control with comparing the beam’s behavior pre and post control. Numerical verifications have been conducted in order to certify the applied control algorithm via time responses and phase portraits. | ||||
| Keywords | ||||
| Cantilever beam; saddle-node bifurcation; simultaneous resonance; positive position feedback; phase plane | ||||
|
Statistics Article View: 22 PDF Download: 28 |
||||
