Influence of Mixing Methods, Special Trays and Storage Time on the Accuracy of two Elastomeric Impressions | ||||
| Al-Azhar Journal of Dentistry | ||||
| Volume 2016, Issue 4, April 2016 | ||||
| DOI: 10.21608/adjg.2016.5076 | ||||
 View on SCiNiTO | ||||
| Authors | ||||
| Noha El Tawiel1; Mohamed El-Hossary2; Eman Essam3 | ||||
| 1B.D.S Tanta University, 2005, Dentist in Al Zahraa Hospital. | ||||
| 2Professor of Crowns and Bridges, Faculty of Dental Medicine “Boys” Cairo,Al-Azhar University. | ||||
| 3Associate Professor, Crowns and Bridges Department, Faculty of Dental Medicine, Al-Azhar University, Girls’ Branch. | ||||
| Abstract | ||||
| This in-vitro study investigated the dimensional accuracy and stability of polyether and polyvinylsiloxane impression materials. The study included the effect of mixing methods where conventional mix versus auto-mixing technique, the effect of special tray on the accuracy of impression and pouring the impressions at different times of storage (1hour, 48 hours and 7 days). Impressions were made for a master model cast of mandibular arch with two prepared abutments; right second premolar and right second molar with a shoulder finish line made as to give a definite margin that was easilydefined where there was an occlusal shoulder and gingival shoulder used for occlusogingival (O-G) measurements. There was an occlusal holes made on occlusal surface of both teeth to be used as a reference points for inter-abutment distance record of the prepared abutments. All dimensions were measured on casts retrieved from impressions made on master model. The impressions were then poured with extra-hard stone into stone casts, according to times under investigations. The results revealed that the polyether elastomeric impression material presented a higher degree of accuracy thanvinylpolysiloxane. The automixing technique showed better results than conventional mixing, while the light- cured special tray presented slightly better dimensions. Also, the one- hour pouring time presented the best dimensions, while two- days and sevendays pouring times had almost the same dimensions. | ||||
| Keywords | ||||
| Elastomeric impression materials; Special trays; Dimensional change | ||||
|
Statistics Article View: 22 |
||||
