DESIGN, ANALYSIS AND REALIZATION IN MICROSTRIP FORM OF THE DOWNCONVERSION AND IF AMPLIFICATION PARTS OF A MICROWAVE RECEIVER | ||||
The International Conference on Electrical Engineering | ||||
Article 38, Volume 2, 2nd International Conference on Electrical Engineering ICEENG 1999, November 1999, Page 368-374 PDF (1.83 MB) | ||||
Document Type: Original Article | ||||
DOI: 10.21608/iceeng.1999.62523 | ||||
![]() | ||||
Authors | ||||
Esmat A. A.1; Mohammed A. N.2; Ayman G. S.3 | ||||
1Professor, Det. Of Microstrip Circuits, Electronics Research Institute, Giza, Egypt. | ||||
2Associate Professor, Det. Of circuits & systems, M.T.C, Cairo, Egypt. | ||||
3MSc., Det. Of Electronic Engineering , M.T.C, Cairo, Egypt. | ||||
Abstract | ||||
By the aid of the Microwave Design System (MDS), software package, the design and analysis of the downconversion and IF amplification parts of a microwave superhytrodyne receiver, operating in the S-band, and the implementation of the designed subsystem in the microstrip form, is presented.. All individual circuits constituting this subsystem are fabricated separately and their characteristics are measured to test their performances and then the integration of these circuits is fabricated again on a single substrate and its characteristics are also tested and measured. | ||||
Keywords | ||||
CAD; S-band; Microstrip; Receiver and Subsystem | ||||
Statistics Article View: 137 PDF Download: 180 |
||||