DEVELOPMENT AND PERFORMANCE EVALUATION OF A PULLING FLAX MACHINE
Abdel-Wahab, M., El-Sharabasy, M., El-Didamony, M. (2012). DEVELOPMENT AND PERFORMANCE EVALUATION OF A PULLING FLAX MACHINE. EKB Journal Management System, 29(3), 973-992. doi: 10.21608/mjae.2020.101806
M. K. Abdel-Wahab; M. M. A. El-Sharabasy; M. I. El-Didamony. "DEVELOPMENT AND PERFORMANCE EVALUATION OF A PULLING FLAX MACHINE". EKB Journal Management System, 29, 3, 2012, 973-992. doi: 10.21608/mjae.2020.101806
Abdel-Wahab, M., El-Sharabasy, M., El-Didamony, M. (2012). 'DEVELOPMENT AND PERFORMANCE EVALUATION OF A PULLING FLAX MACHINE', EKB Journal Management System, 29(3), pp. 973-992. doi: 10.21608/mjae.2020.101806
Abdel-Wahab, M., El-Sharabasy, M., El-Didamony, M. DEVELOPMENT AND PERFORMANCE EVALUATION OF A PULLING FLAX MACHINE. EKB Journal Management System, 2012; 29(3): 973-992. doi: 10.21608/mjae.2020.101806

DEVELOPMENT AND PERFORMANCE EVALUATION OF A PULLING FLAX MACHINE

Misr Journal of Agricultural Engineering
Article 6, Volume 29, Issue 3, July 2012, Page 973-992  XML PDF (1.12 MB)
Document Type: Original Article
DOI: 10.21608/mjae.2020.101806
View on SCiNiTO View on SCiNiTO
Authors
M. K. Abdel-Wahab1; M. M. A. El-Sharabasy2; M. I. El-Didamony3
1Prof. of Agric. Eng., Fac. of Agric., Zagazig Univ., Egypt.
2Assist. Prof. of Agric. Eng., Fac. of Agric., Zagazig Univ., Egypt.
3Assist Resarcher, Eng. Res. Inst., Agric. Res. Centre, Giza, Egypt.
Abstract
The laboratory experiments were carried out through the successive agricultural seasons of (2008-2009) at the center laboratory of Agricultural Engineering Research Institute (AEnRI) Dokki – Giza. Field experiments were conducted at the experimental farms of Gemmaiza Research Station, Gharbia Governorate, during the harvesting season of (2009), to develop the lentil pulling machine to be suitable for pulling flax crop using available locally materials to construct, modify and develop flax pulling machine. The developed machine consists of two vertical conveyor belts and power transmission. The developed machine was evaluated by measuring pulling efficiency, harvester performance (actual field capacity and field efficiency), fuel consumption rate, energy requirement and criterion cost under the studied variables; machine forward speeds of 1.44, 2.16, 2.57 and 4.5 km/h, finger rotating speeds of 0.393, 0.524, 0.654 and 0.837 m/s and soil moisture contents of 15.75, 18.35, 21.96 and 29.24 % (w.b). The obtained results concluded that the developed machine can be worked at the optimum operating parameters of 2.16 km/h forward speed, 0.654 m/s finger rotating speed (kinematic ratio of 1.18) and 21.96 % soil moisture content to obtain the suitable performance in pulling efficiency of 98.30%, actual field capacity of 0.46 fed/h, field efficiency of 80.00%, fuel consumption of 5.60 l/h, energy requirements of 38.7 kW.h/fed and criterion cost of 163.70 L.E/fed.
References
Abdel-Wahab, M. K. (1987): Prototype of a lentil walker puller harvester. Misr J. Agric. Eng., 4(4): 351-364.

Abdel-Wahab, M. K. (1994): Development of a lentil harvesting machine and its power requirement. Misr J. Agric. Eng., 11(2): 559-568.

Awady, M. N. (1978): Tractor and farm machinery. Text Book, Faculty of Agriculture, Ain-Shams University. pp. 164-167.

Bosoi, E. S; O. V. Verniaev, I. I. Smirnov and E. G. Sultan-Shakh (1991): Theory, construction and calculations of agricultural machines. Volume two. Russian translations series 83. A. A. BALKEMAIROTT-ERDAM. 1991.

Economic Affairs Sector (2009): Bulletin of the agricultural statistics, Ministry of Agricultural and land reclamation, A.R.E. Vol.1:61.

El-Sharabasy, M. M. A. (2003): Development of a simplified machine suits for pulling process of lentil crop. Ph. D. Thesis, Agric. Eng. Dept., Faculty. of Agric., Zagazig Univ., Egypt.

Hamad, S. A; A. F. EI-Sahrigi, M. M. Ibrahim and A. S. Hamam (1991): Development of harvesting machine suitable for flax in Egypt, Misr J. Agric. Eng., 8(2): 142-153.

Hunt, D. R. (1983): Farm power and machinery management. 8th Ed. Iowa state Univ., Press Ames, USA. Ames, Iowa, USA: 364-368.

Hunt, D. R. (1986): Engineering methods for agricultural production. The AVT. Publ. Co., INC. Westport USA.

Ibrahim, M. M. (1983): Study of the different valuables found in flax harvesting device. Ph. D. Thesis, Agric. Eng. Insti. Minsk, USSR. (C.F. El-Sharabasy, 2003).

Kepner, R. A; R. Bainer and E. I. Barger (1982): Principles of Farm machinery. Third Edition, AVI publishing Company, INC. USA.

Klenin N. I; I. F. Popov and V. A. Sakun (1985): Agricultural machines, theory of operation, combination of controlling parameters and the conditions of operation. Amerid Publishing  C., Pvt. Ltd., New Delhi, India.

Rodjief, F; B. Tokarief and B. Besakhoviedge (1986): The Agric. Reference. M1R publishers Moscow, USSR.

Statistics
Article View: 149
PDF Download: 239