PERFORMANCE EVALUATION OF TWO SYSTEMS FOR MIXING AND PROCESSING FEED ADDITIVES AND CONCENTRATES | ||||
| Misr Journal of Agricultural Engineering | ||||
| Article 6, Volume 29, Issue 2, April 2012, Page 611-632 PDF (608.73 K) | ||||
| Document Type: Original Article | ||||
| DOI: 10.21608/mjae.2012.102275 | ||||
 View on SCiNiTO | ||||
| Authors | ||||
| M. M. Morad1; M. M. A. El-Sharabasy2; S.M. A bdel-Samie3 | ||||
| 1Professor of Agric. Eng., Fac. of Agric., Zagazig Univ., Egypt. | ||||
| 2Assist. Prof. of Agric. Eng., Fac. of Agric., Zagazig Univ., Egypt. | ||||
| 3Graduate student, Agric. Eng., Fac. of Agric., Zagazig Univ., Egypt. | ||||
| Abstract | ||||
| The main experiments were carried out in a local factory for manufacturing feed additives and concentrates in El- Obour city, Kalubia Governorate to study the effect of some operating parameters on the performance of two mixing units. Experiments were carried out using both big mixer (Buhler) and small mixer (Ribbon) under four different batch sizes, four different mixing times and three different carrier materials. Evaluation of the performance of both mixers was carried out taking into consideration the mixer productivity, homogeneity, coefficient of variation, consumed energy and mixing cost. The obtained results reveal t the following: The big mixer is recommended to be used under the following conditions: (Batch size of between 1000 and 1200 kg; mixing time of between 10 and 15 min, and carrier materials of calcium carbonate and corn gluten with ratio of 3:1). The small mixer is recommended to be used under the following conditions: (Batch size of between 200 and 250 kg; mixing time of between 40 and 60 min, and carrier materials of Maltodextrin and sucrose with ratio of 1:1). | ||||
| References | ||||
|
ASAE (1997a): Cubes, Pellets, an Crumbles-Definitions and methods for determining density, durability, and moisture. Standards 1997. Am. Soc. Agric. Eng., St. Joseph, MI.
ASAE (1997b): Method of determining and expressing fineness of feed materials by Sieving. Standards 1997. Am. Soc. Agric. Eng., St. Joseph, MI.
Avik, S. and C. R. Wassgrena (2009): Simulation of a continuous granular mixer: Effect of operating conditions on flow and mixing. Chemical Engineering Science 64: 2672 – 2682.
Clark, P. M. and K. C. Behnke (2006): Effects of pelleting protein concentrate pellets on feed mill throughput and electrical efficiency. Poult. Sci. 83 (Suppl. 1):170(Abst.).
Coates, P. M. and K. Tanaka (1992): New developments in fatty acid oxidation. New York: willey-Liss.
Dirksen, G. U; H. G. Liebich and E. Mayer (1980): Feed manufacturing problems-incomplete mixing and segregation. C-555 Revised. KSU Cooperative Extension Service. Manhattan, KS.
Portillo, P. M; M. G. Ierapetritou and F. J. Muzzio (2007): Characterization of continuous convective powder mixing processes. Powder Technology 182: 368–378.
Traylor, S. L. (1997): Effects of feed processing on diet characteristics and animal performance. Masters Thesis, Kansas State University, Manhattan, KS. | ||||
|
Statistics Article View: 99 PDF Download: 154 |
||||
