SOLIDS REMOVAL IN A RECIRCULATING AQUACULTURE SYSTEM | ||||
| Misr Journal of Agricultural Engineering | ||||
| Article 24, Volume 28, Issue 4, October 2011, Page 1178-1196 PDF (706.39 K) | ||||
| Document Type: Original Article | ||||
| DOI: 10.21608/mjae.2011.102635 | ||||
 View on SCiNiTO | ||||
| Authors | ||||
| El-Sayed G. Khater1; Samir A. Ali2; Adel H. Bahnasawy3; Montasser A. Awad2 | ||||
| 1Assist. Lecturer,Ag. Eng. Dept., Fac. of Ag., Benha Univ., Egypt. | ||||
| 2Assoc. Prof., Ag. Eng. Dept., Fac. of Ag., Benha Univ., Egypt. | ||||
| 3Prof. of Ag. Eng., Ag. Eng. Dept., Fac. of Ag., Benha Univ., Egypt. | ||||
| Abstract | ||||
| The objective of this work was to investigate the efficiency of both double drain and screen filter on solids removal in recirculating aquaculture system to improve the water quality and increase the fish growth rate. A model was developed to determine the solids removal in recirculating aquaculture system. By fitting the predictions of the model to measured settleable and suspended solids, settleabe solids removal was determined that about 0.0304 to 0.0556 kg m-3 (30.40 to 55.60 mg l-1) while it was 0.039 kg m-3 (39 mg l-1) for the theoretical approach and suspended solids removal was determined that about 0.0123 to 0.0806 kg m-3 (12.30 to 80.60 mg l-1) while it was from 0.0124 to 0.1425 kg m-3 for the theoretical approach. It was calculated that the hydrocyclone and drum filter efficiency to remove the solids from the system ranged from 27.4 to 57.79 % and15.46 to 57.71 % respectively. It was calculated that the hydrocyclone and drum filter efficiency to remove the solids from the system ranged from 27.4 to 57.79 % and15.46 to 57.71 % respectively. The daily average of settleable and suspended solids removed by hydrocyclone and drum filter ranged from 0.33 to 6.26 kg/day and 0.11 to 11.43 kg/day, respectively. The model results were in a reasonable agreement with the experimental ones. | ||||
| Keywords | ||||
| Model - Settleable solids; Suspended solids; Hydrocyclone; Drum filter | ||||
| References | ||||
|
APHA (1998). Standard Methods for Examination of Water and Wastewater, American Public Health Association, American Water Works Association, Water Pollution Control Federation Washington, DC.
Bai, C. (2007). President’s column. World Aquaculture Magazine, 38 (4): 3.
Bergheim, A., S. Cripps and H. Litved (1998). A system for the treatment of sludge from land-based fish farms. Aquatic Living Resources, 11: 279–287.
Boyd, C. E. (1982). Water quality in warm water in ponds. Auburn university, Agricultural Experiment station, Auburn, Alabama, 35 pp.
Brinkera A., H. G. SchrÖderc, and R. RÖscha (2005). A high-resolution technique to size suspended solids in flow-through fish farms. Aquacultural Engineering, 32 (4): 325–341.
Chapman, P. E., J. D. Popham, J. Griffin and J. Michaelson (1987). Differentiation of physical from chemical toxicity in solid waste fish bioassay. Water, Air, and Soil Pollution 33: 295–309.
Chen, S., D. E. Coffin and R. F. Malone (1994). Suspended solids control in recirculating aquaculture systems. In: Timmons, M.B., Losordo, T.M. (Eds.), Aquaculture Water Reuse Systems: Engineering Design and Management. Elsevier, Amsterdam, pp. 61– 100.
Chen, S., M. B. Timmons, D .J. Aneshansley, and J. J. Bisogni (1993). Suspended solids characteristics from recirculating aquacultural systems and design implications. Aquaculture, 112: 143–155
Chesness, J. L., W. H. Poole and T. K. Hill (1975). Settline basin design for raceway fish production systems. Trans. of the ASAE, paper no. 74 – 5005.
Couturier, M., T. Trofimencoff, J. U. Buil and J. Conroy (2009). Solids removal at a recirculating salmon-smolt farm. Aquacultural Engineering, 41 (3): 71–77.
Cripps, S. and A. Bergheim (2000). Solids management and removal for intensive land-based aquaculture production systems. Aquacultural Engineering, 22 (1 – 2): 33 – 56.
d’Orbcastel, R. E., J. P. Blancheton and A. Belaud (2009).Water quality and rainbow trout performance in a Danish Model Farm recirculating system: Comparison with a flow through system. Aquacultural Engineering, 40 (2): 135–143.
Davidson, J. and S. T. Summerfelt (2005). Solids removal from a coldwater recirculating system—comparison of a swirl separator and a radial-flow settler. Aquacultural Engineering 33: 47–61.
Delos-Reyes, A. A. and R. F. Malone (1996). Design and evaluation of a commercial-scale, paddle-washed floating bead filter. In Successes and Failures in Commercial Recirculating Aquaculture, editors Northeast Regional Agricultural Engineering Service (NRAES). NRAES-98, 1: 183 – 195.
Fritz, J. J. (1985). Mathematical models for waste stabilization ponds. In: S. E. Jorgenson and M. J. Gromiec (eds.), Mathematical Models in Biological Waste Water Treatment, Elsevier, Amsterdam. Pp. 169 – 241.
Fritz, J. J., A. C. Middleton and D. D. Meredith (1979). Dynamic process modeling for wastewater stabilization ponds. Jour. Water Poll. Control Fed., 51: 2724 – 2743.
Hopkins, T. A. and W. E. Manci (1989). Feed conversion, waste and sustainable aquaculture, the fate of feed. Aquaculture Magazine, 15 (2): 32 – 36.
James, A. (1984). An Introduction to water quality modeling. Wiley Interscience, New York. 234 p.
James, A. (1984b). Modelling of sedimentation. In: A. James (ed.), An Introduction to Water Quality Modelling. Wiley Interscince, New York, pp. 169 – 181.
Jauncey, K. and B. Ross (1982). A guide to tilapia feeds and feeding. Institute of aquaculture, university of sterling, Scotland. 111 pp.
Libey, G. S. (1993). Evaluation of a drum filter for removal of solids from recirculating aquaculture system. In: Techniques for Modern Aquaculturre, Wang, J. K. (editors), Saint Joseph, Michigan, ASAE.
Losordo, T. M. and A. O. Hobbs (2000). The design and operational characteristics of the CP&L/EPRI fish barn: a demonstration of recirculating aquaculture technology. Aquacultural Engineering, 22: 3-16.
Merino, G. E., R. H. Piedrahita and D. E. Conklin (2007). Settling characteristics of solids settled in a recirculating system for California halibut (Paralichthys californicus) culture. Aquacultural Engineering, 37, 79 – 88.
Patterson, R. and K. Watts (2003). Micro-particles in recirculating aquaculture systems: microscopic examination of particles. Aquacultural Engineering, 28 (2): 115–130.
Pfeiffer, J. T., A. Osborn and M. Davis (2008). Particle sieve analysis for determining solids removal efficiency of water treatment components in a recirculating aquaculture system. Aquacultural Engineering, 39 (1): 24 – 29.
Piedrahita, R. H. and P. Giovannini (1989). Diel aquaculture models: listings, descriptions and operating instructions. Technical Committee Meeting 1989, PD/A CRSP, Davis, CA, 50 pp.
Piedrahita, R. H., W. H. Zachritz, U. K. Fitzsimmons and C. Brckway (1996). Evaluation and improvement of solids removal systems for aquaculture. In Successes and Failures in Commercial Recirculating Aquaculture, editors Northeast Regional Agricultural Engineering Service (NRAES). NRAES-98, 1: 141 – 150.
Rakocy, J. E. (1989). Tank culture of tilapia. In the biology and culture of tilapia, ed. R. S. V. Pullin & R. H. Lowe-McConell-ICLARM conference proceedings 7. International center for living aquatic resources management, manila, the Philippines.
Sandu, S., B. Brazil and E. Hallerman (2008). Efficacy of a pilot-scale wastewater treatment plant upon a commercial aquaculture effluent I. Solids and carbonaceous compounds. Aquacultural Engineering, 39 (2): 78–90.
Stechey, D. and Y. Trudell (1990). Aquaculture wastewater treatment: Wastewater characterization and development of appropriate treatment technologies for the Ontario trout production industry. Reported prepard for Environmental Services. Water Resources, Ministry of the Environment. Queen’s Printer for Ontario.
Steicke, C., V. Jegatheesan and C. Zeng (2007). Mechanical mode floating medium filters for recirculating system in aquaculture for higher solids retention and lower freshwater usage. Bioresource Technology, 98 (17): 3375 – 3383.
Summerfelt, R. C. and C. R. Penne (2005). Solids removal in a recirculating aquaculture system where the majority of flow bypasses the microscreen filter. Aquacultural Engineering, 33 (2): 214 – 224.
Summerfelt, S. T. (1996). Engineering design of modular and scaleable recirculating systems containing circular tank, microscreen filters, fluidized-sand biofilters, cascade aerators, and low head or u-tube oxygenators. In Successes and Failures in Commercial Recirculating Aquaculture, editors Northeast Regional Agricultural Engineering Service (NRAES). NRAES-98, 1: 217 – 244.
Tchobanoglous, G. and E. D. Schroeder (1985). Water quality: characteristics, modeling, modification. Addison-Wesley, Reading MA. 768 p.
Timmons, M. B. and J. M. Ebeling (2007). Recirculating aquaculture. Cayuga Aqua Ventures, Ithaca, NY.
Timmons, M. B., J. M. Ebeling, F. W. Wheaton, S. T. Summerfelt and B. J. Vinci (2002). Recirculating aquaculture systems. 2nd Edition. NRAC publication No. 01-002. Printing, Robert E. Kvieger Publishing Company. Malabar, Florida.
Timmons, M. B., S. T. Summerfelt and B. J. Vinci (1998). Review of circular tank technology and management. Aquacultural Engineering, 18: 51 – 69.
Twarowska, J. G., P. W. Westerman and T.M. Losordo (1997). Water treatment and waste characterization evaluation of an intensive recirculating fish production system. Aquacultural Engineering, 16: 133 – 147.
Wong, K. (2001). Enhanced solids removal for aquaculture raceways. Doctoral Dissertation. Biological and Agricultural Engineering, University of California, Davis, CA.
Zhu, S. and C. Chen (2001). Effects of organic carbon on nitrification rate in fixed film biofilters. Aquacultural Engineering, 25 (1): 1–13. | ||||
|
Statistics Article View: 373 PDF Download: 487 |
||||
