Comparative Simulation Analysis of Dispersion Mitigation Techniques Using Symmetrical-DCF, FBG and CFBG in High Speed DWDM Networks | ||||
| Menoufia Journal of Electronic Engineering Research | ||||
| Article 5, Volume 29, Issue 2, July 2020, Page 32-40 PDF (1.37 MB) | ||||
| Document Type: Original Article | ||||
| DOI: 10.21608/mjeer.2020.103269 | ||||
 View on SCiNiTO | ||||
| Authors | ||||
| Abd El-Naser A. Mohammed; Ahmed Nabih Zaki Rashed; Fatma Mohammed Aref | ||||
| Electronics and Electrical Communications Engineering Department, Faculty of Electronic Engineering, Menouf 32951, Menoufia University. | ||||
| Abstract | ||||
| The performance of the dense wavelength division multiplexing (DWDM) network is severely limited by the chromatic dispersion. So, it is crucial to mitigate and compensate this dispersion. In this paper, the different dispersion compensation techniques are discussed and compared. The DWDM system performance is evaluated by utilizing these dispersion mitigation techniques. The techniques used are dispersion compensation fiber (DCF) with symmetrical compensation scheme, Fiber Bragg Grating (FBG) and Chirped Fiber Bragg Grating (CFBG). The system performance is investigated for 16-channels DWDM network using Return-to-Zero (RZ) and Non-Return-to-Zero (NRZ) modulation formats over transmission distance up to 200 km at 2.5 and 5 Gb/s data flow rate per channel. The system performance is evaluated according to Quality factor (Q-factor), Optical Signal to Noise Ratio (OSNR) and Signal to Noise Ratio (SNR) through Eye Diagrams. The DWDM network is implemented by using Optisystem simulator. The simulation results are outlined in tables indicating the most efficient dispersion compensation technique. The simulation results revealed that the systems using FBG as dispersion compensator offers better performance and larger Q-factor especially for longer transmission distance. FBG achieved Q-factor of approximately 38 and 62 which are the larger Q-factor values compared to other dispersion compensation methods at data rate of 2.5 Gb/s over 200 km fiber length for NRZ and RZ respectively. Furthermore, as data rate increases, the performance is reduced adversely due to pulse broadening causing interference with adjacent channels. Finally, the systems using RZ format provides better performance than those that using NRZ although, NRZ has less pulse broadening due to its reduced bandwidth. | ||||
| References | ||||
|
[1] P. Kaur, H. Sarangal, “Simulative Investigation and Comparison of 32 x 40 Gbps DWDM System Using Different Dispersion Compensation,” Int. J. of Adv. Res. in Comp. Sci. & Software Eng. (IJARCSSE), vol. 6, no. 4, pp.489 – 494, 2016. [2] V. Senthamizhselvan, et al., “Performance Analysis of DWDM Based Fiber Optic Communication with Different Modulation Schemes and Dispersion Compensation Fiber,” Int. J. of Research in Eng. & Tech. (IJRET), vol. 03, no. 3, pp. 287 – 290, March 2014. [3] A. Bhardwaj, G. Soni, “Performance Analysis of 20 Gbps Optical Transmission System Using Fiber Bragg Grating,” Int. J. of Scientific & Research Pub. (IJSRP), vol. 5, no. 1, pp. 1 – 4, Jan. 2015. [4] Meenakshi, et al., “Comparative Analysis of Different Dispersion Compensation Techniques on 40 Gbps DWDM System,” Int. J. of Technol. Enhancements & Emerging Eng. Research (IJTEEE), vol. 3, no. 6, pp. 34 –38, 2015. [5] J. Choudhary, et al., “Comparative analysis of DWDM system using different modulation and dispersion compensation techniques at different bit rates,” Int. J. of Adv. Research in Computer & Communication Eng. (IJARCCE), vol. 3, no. 5, pp. 6512 – 6518, May 2014. [6] M. Kaur, H. Sarangal, “Performance Comparison of Pre-, Post- and Symmetrical-Dispersion Compensation Techniques using DCF on 40Gbps WDM System,” Int. J. of Advanced Research in Electronics and Communication Engineering (IJARECE), vol. 4, no. 3, pp. 494 – 496, March 2015. [7] Bo-ning HU, Wang Jing, Wang Wei, Rui-mei Zhao, “Analysis on Dispersion Compensation with DCF based on Optisystem,” IEEE 2nd Int. Conf. on Industrial & Information Sys. (lIS 2010), vol. 2, pp. 40 – 43, 2010. [8] M. Kaur, H. Sarangal, P. Bagga, “Dispersion Compensation with Dispersion Compensating Fibers (DCF),” Int. J. of Advanced Research in Computer and Communication Engineering (IJARCCE), vol. 4, no. 2, pp. 354 – 356, February 2015. [9] M. Kaur, H. Sarangal, “Simulative Investigation of 32x10, 32x20 and 32x40 Gb/s DWDM Systems with Dispersion Compensating Fibers,” International Journal of Signal Processing, Image Processing and Pattern Recognition (IJSIP), vol. 8, no. 8, pp. 127 – 134, 2015. [10] M. Sharma, P. K. Raghav, R. Chaudhary, A. Sharma, “Analysis on Dispersion Compensation in WDM Optical Network using Pre, Post and Symmetrical DCF based on Optisystem,” MIT International Journal of Electronics and Communication Engineering, vol. 4, no. 1, pp. 58 – 63, Jan. 2014. [11] E. Ibrahim Essa, “Software Simulation the Hybrid Dispersion Compensation Schemes Based on the 16 × 40Gb/s DWDM Using RZ Modulation Format,” Int. J. of Advanced Research in Computer Science and Software Eng. (IJARCSSE), vol. 2, no. 8, pp. 202 – 208, Nov. 2012. [12] Z. Hu, S. Kartalopoulos, “Simulation models and Evaluation of Pre- and Post- Dispersion Compensation of DWDM Links Using a Bidirectional DCF with FBG Reflectors,” The 9th World Scientific & Eng. Acad. & Society (WSEAS), Int. Conf. on Comm., No. 38, Wisconsin, USA, 2005. [13] U. Bansal, K. Kaur, “Capacity Enhancement of DWDM system using EDFA and DCF with narrow channel spacing,” Int. J. of Appl. Sci. & Eng. Res.(IJASER), vol. 4, no. 1, pp. 147–150, Feb. 2015. [14] M. Sharma, P. K. Raghav, R. Chaudhary, A. Sharma, “Analysis on Dispersion Compensation in WDM Optical Network using Pre, Post and Symmetrical DCF based on Optisystem,” MIT International Journal of Electronics and Communication Engineering, vol. 4, no. 1, pp. 58 – 63, Jan. 2014. [15] Meenakshi, Jyotsana, Jyoteesh Malhotra, “Comparative Analysis of Different Dispersion Compensation Techniques On 40 Gbps DWDM System,” International Journal of Technology Enhancements and Emerging Engineering Research (IJTEEE), vol. 3, no. 06, pp. 34 – 38, 2015. [16] M. Kaur, H. Sarangal, P. Bagga, “Dispersion Compensation with Dispersion Compensating Fibers (DCF),” Int. J. of Advanced Research in Computer and Communication Engineering (IJARCCE), vol. 4, no. 2, pp. 354 – 356, February 2015. [17] D. Dey, Neha, “Compensation in Optical Fiber WDM System Using Different Compensation Techniques,” Int. J. of Advanced Res. in Computer Science and Software Eng. (IJARCSSE), vol. 4, no. 5, pp. 744 – 751, May 2014. [18] K. Kumar, A. K.Jaiswal, M. Kumar and N. Agrawal, “Performance Analysis of dispersion compensation using Fiber Bragg Grating (FBG) in Optical Communication,” Int. J. of Current Engineering and Technology (IJCET), vol. 4, no. 3, pp. 16 – 30, June 2014. [19] S. Kumar, Prof. A. K. Jaiswal, Er. Mukesh Kumar, Er. Rohini Saxena, “Performance Analysis of Dispersion Compensation in Long Haul Optical Fiber with DCF,” IOSR J. of Electronics and Communication Eng. (IOSR – JECE), vol. 6, no. 6, pp. 19 – 23, Jul. - Aug. 2013. [20] N. M. Nawawi, “Dispersion Compensation Dense Wavelength Division Multiplexing (DC-DWDM) for Nonlinearity Analysis at Various Propagation Distance and Input Power,” IEEE Int. Conf. on Computer, Communication, and Control Technology (I4CT 2015), pp. 21 – 23, April 2015. [21] V. Bobrovs, S. Spolitis and G. Ivanovs, “Comparison of Chromatic Dispersion Compensation Techniques for WDM-PON solution,” IEEE, 2nd Baltic Congress on Future Internet Communications, 2012. [22] Yin, Xin, et al., “Performance Evaluation of Single Carrier 40-Gbit/s Downstream for Long-Reach Passive Optical Networks,” IEEE International Conference on Optical Network Design and Modeling, Stockholm, Sweden, 19 May, 2014. [23] K. Kumar, A. K.Jaiswal, M. Kumar and N. Agrawal, “Performance Analysis of dispersion compensation using Fiber Bragg Grating (FBG) in Optical Communication,” Int. J. of Current Engineering and Technology (IJCET), vol. 4, no. 3, pp. 16 – 30, June 2014. [24] Neha and R. L Sharma, “Performance Analysis of 8-Channel WDM System using Symmetrical DCF and Optigrating,” International Journal of New Trends in Electronics and Communication (IJNTEC), vol. 2, no. 4, June 2014. [25] Aashima Bhardwaj, Gaurav Soni, “performance Analysis of 20Gbps Optical Transmission System Using Fiber Bragg Grating,” International Journal of Scientific and Research Publications (IJSRP), vol. 5, no. 1, pp. 1 – 4, January 2015. [26] Kaushal Kumar, A. K. Jaiswal, Mukesh Kumar and Nilesh Agrawal, “Performance Analysis of dispersion compensation using Fiber Bragg Grating (FBG) in Optical Communication,” International Journal of Current Engineering and Technology (IJCET), vol. 4, no. 3, pp. 1527 – 1531, June 2014. [27] P. Spalevic, D. Milic, B. Jaksic, M. Petrovic, I. Temelkovski, “Simulation influence of the thermal noise of PIN photodetector on performance DWDM optical network,” XLVII Int. Scientific Conf. on Information, Comm. and Energy Systems and Tech., ICEST 2012, Sofia, vol. 2, pp. 315 – 318, 28-30 June 2012 | ||||
|
Statistics Article View: 1,000 PDF Download: 358 |
||||
