MODIFICATION OF WATER APPLICATION UNIFORMITY AMONG CLOSED CIRCUIT TRICKLE IRRIGATION SYSTEMS | ||||
| Misr Journal of Agricultural Engineering | ||||
| Article 9, Volume 27, Issue 3, July 2010, Page 903-923 PDF (1.1 MB) | ||||
| Document Type: Original Article | ||||
| DOI: 10.21608/mjae.2010.105751 | ||||
 View on SCiNiTO | ||||
| Authors | ||||
| H.A. Abdel-Ghani1; M.Y. Tayel1; D.A. Lightfoot2; A. M. El-Gindy3 | ||||
| 1Department of Water Relations and Field Irrigation, National Research Center, Dokki, Giza, Egypt. | ||||
| 2Department of Soil, Plant and Agricultural Systems, University of Southern Illinois, USA. | ||||
| 3Department of Agricultural Engineering, Faculty of Agriculture, Ain Shams University, Cairo, Egypt. | ||||
| Abstract | ||||
| The aim of this research was determine the maximum application uniformity of closed circuit trickle irrigation systems designs. Laboratory tests carried out for Two types of closed circuits: a) One manifold for lateral lines or Closed circuits with One Manifold of Trikle Irrigation System (COMTIS); b) Closed circuits with Two Manifolds of Trikle Irrigation System (CTMTIS), and c) Traditional Trikle Irrigation System (TTIS) as a control. Three lengths of lateral lines were used, 40, 60, and 80 meters. PE tubes lateral lines: 16 mm diameter; 30 cm emitters distance, and GR built-in emitters 4 lph when operating pressure 1 bar. Experiments were conducted at the Agric. Eng. Res. Inst., ARC, MALR, Egypt. With COMTIS the emitter flow rate was 4.07, 3.51, and 3.59 lph compared to 4.18, 3.72, and 3.71 lph with CTMTIS and 3.21, 2.6, and 2.16 lph with TTIS (lateral lengths 40, 60, and 80 meter respectively). Uniformity varied widely within individual lateral lengths and between circuit types. Under CTMTIS uniformity values were 97.74, 95.14, and 92.03 %; with COMTIS they were 95.73, 89.45, and 83.25 %; and with TTIS they were 88.27, 84.73, and 80.53 % (for lateral lengths 40, 60, 80 meter respectively). The greatest uniformity was observed under CTMTIS and COMTIS when using the shortest lateral length 40 meter, then lateral length 60 meter, while the lowest value was observed when using lateral length 80 meter this result depends on the physical and hydraulic characteristics of the emitter and lateral line. CTMTIS was more uniform than either COMTIS or TTIS. Friction losses were decreased with CTMTIS in the emitter laterals at lengths 40 meter compared to TTIS and COMTIS. Therefore, differences may be related to increased friction losses when using TDIS and COMDIS. | ||||
| Keywords | ||||
| Trickle Irrigation; Closed Circuits; Manifold; Lateral; Flow Rate; Uniformity | ||||
| References | ||||
|
Alizadeh, A. (2001). Principles and Practices of Trickle Irrigation. Ferdowsi University, Mashad, Iran.
ASAE (1983). Designs and Operation of Farm Irrigation Systems. St. Joseph, MI: 49085 ASAE. Monograph No. 3. 189-232.
ASAE STANDARDS, 43rd ed. (1996). EP458. Field Evaluation of Microirrigation Systems. St. Joseph, Mich. ASAE.756-761.
ASAE (1999). Design and Installation of Microirrigation Systems. p.875-879. In: ASAE Standards, 2000, EP405.1, ASAE, St. Joseph, MI.
ASAE STANDARDS (2003). EP405.1 FEB03. Design and Installation of Microirrigation Systems.. ASAE, St. Joseph, Mich. P.901-905.
Berkowitz, S.J. (2001). Hydraulic performance of subsurface wastewater drip systems. In On-Site Wastewater Treatment: Proc. Ninth International Symposium on Individual and Small Community Sewage Systems.. St. Joseph, MI: ASAE. p.583-592.
Bombardelli, F.A. and M. H. Garcia (2003). Hydraulic design of largediameter pipes. Journal or Hydraulic Engineering, Vol. 129(11): 839–846.
Burt, C.M.; A.J. Clemens; T.S. Strelkoff; K.H. Solomon; R.D. Blesner; L.A. Hardy and T.A. Howell (1997). Irrigation performance measures: Efficiency and uniformity. J. Irrig. and Drain. Div., ASCE. 123(6): 423-442.
Camp, C.R.; E.J. Sadler and W.J. Busscher (1997). A comparison of uniformity measure for drip irrigation systems. Transactions of the ASAE, 40: 1013-1020.
Capra, A and B. Scicolone (1998). Water quality and distribution uniformity in drip/trickle irrigation systems. J. Agric. Eng. Res., 70: 355-365.
Dospekhov, B.A. (1984).Field Experimentation Statistical Procedures,. Translated from the Russian by V. Kolykhamatov. Mir Publishers, Moscow. 351 p.
Gillbert, R.G.; F.S. Nakayama and D.A. Bucks (1979). Trickle irrigation: Prevention of clogging, Trans. ASAE. 22(3): 514-519.
Hathoot, H.M.; A.I. Al-Amoud and F.S. Mohammed (1991). “Analysis of a Pipe with Uniform Lateral Flow.” Alexandria Eng. J., Alexandria, Egypt, 30, No. 1), C49-C54.
Hathoot, H.M.; A.I. Al-Amoud and F.S. Mohammed (1993). Analysis and Design of Trickle Irrigation Laterals. J. Irrig. And Drain. Div. ASAE, 119, No. 5, Paper No. 3937, 756-767.
Khatri, K.C.; I.P. Wu; H.M. Gitlin and Phillips (1979). A.L. Hydraulics of Micro Tube Emitters. J. Irrig. Drain. Div., ASCE, 105, No. 2, 163-173.
Kirnak, H.; E. Dogan; S. Demir and S. Yalcin (2004). Determination of hydraulic performance of trickle irrigation emitters used in irrigation system in the Harran Plain. Turk. J. Agric. For. 28: 223-230.
Lamm, F.R.; T.P. Trooien; G.A. Clark; L.R. Stone; M. Alam; D.H. Rogers and A.J. Chlgel (2002). Using beef lagoon effluent with SDI. In Proc. Irrigation Assn. Int’l. Irrigation Technical Conf., October 24-26, 2002, 8 pp. New Orleans, LA. Available from Irrigation Assn., Falls Church, Virginia. Also available at: http://www.oznet.ksu.edu/sdi/Reports/2002/MWIAPaper.pdf
Mizyed, N. and E.G. Kruse (1989). Emitter discharge evaluation of subsurface trickle irrigation systems. Transactions of the ASAE, 32: 1223-1228.
Mogazhi, H.E.M. (1998). Estimating Hazen-Williams coefficient for polyethylene pipes. J. Transp. Eng., 124-2: 197–199.
Nakayama, F.S. and D.A. Bucks (1981). Emitter clogging effects on trickle irrigation uniformity. Trans. ASAE. 24(1): 77-80.
Nakayama, F.S. and D.A. Bucks (1986). Trickle Irrigation for Crop Production- Design, Operation, and Management, Developments in Agricultural Engineering 9. Elsevier, New York.
Netafim Irrigation, Inc. (2002). Bioline design guild. www.netafim.com, Fresno, CA. Perkins, J.P. 1989. On-site wastewater disposal. National Environmental Health Association, Chelsea, MI: Lewis Publishers, Inc.
Ortega, J.F.; J.M. Tarjuelo and J.A. de Juan (2002). Evaluation of irrigation performance in localized irrigation system of semiaridregions (Castilla-La Mancha, Spain): Agricultural EngineeringInternational: CIGR Journal of Scientific Research and Development. 4: 1-17.
Perold, R.P. (1977). Design of Irrigation Pipe Laterals. J. Irrig. Drain. Div., ASCE, 103, No. 2, 179 - 195.
Safi, B.; M.R. Neyshabouri; A.H. Nazemi; S. Masiha and S.M. Mirlatifi (2007). Subsurface irrigation capability and effective parameters on onion yield and water use efficiency. J. Scientific Agricultural. 1: 41-53.
Talozi, S.A. and D.J. Hills (2001). Simulating emitter clogging in a microirrigation subunit. Trans. ASAE. 44(6): 1503-1509.
Watters, G.Z.; J. Urbina and J. Keller (1977), “Trickle Irrigation Emitter Hose Characteristics.” Proceedings of International Agricultural Plastics Congress, San Diego, California, 67-72.
Watters, G.Z. and J. Keller (1978). Trickle Irrigation Tubing Hydraulics. ASAE Technical, Paper No. 78-2015, St. Joseph, Mich. 17
Warrick, A.W. and M. Yitayew (1988). Trickle Lateral Hydraulics. I: Analytical Solution. J. Irrig. Drain. Engrg., ASCE, 114, No. 2, 281-288.
Williams, G.S. and A. Hazen (1960). Hydraulic Tables; 3rd edition. New York, John Wiley and Sons.
Wu, I.P. and H.M. Gitlin (1979). Hydraulics and Uniform for Drip Irrigation. Journal of the Irrigation and Drainage Division, ASCE, Vol. 99, (IR3): 157-168. Paper 9786, June.
Yitayew, M. and A.W. Warrick (1988). Trickle Lateral Hydraulics. II: Design and Examples. J. Irrig. Drain. Engrg. , ASCE, 114, No. 2, 289-300. | ||||
|
Statistics Article View: 113 PDF Download: 193 |
||||
