EXAMINATION OF CAVITATION EROSION PARTICLES MORPHOLOGY IN CORROSIVE WATERS | ||||
JES. Journal of Engineering Sciences | ||||
Article 14, Volume 40, No 6, November and December 2012, Page 1793-1814 PDF (1.07 MB) | ||||
Document Type: Research Paper | ||||
DOI: 10.21608/jesaun.2012.114620 | ||||
View on SCiNiTO | ||||
Authors | ||||
S. A. Karrab1; M. A. Doheim1; Mohammed S. Aboraia1; S. M. Ahmed2 | ||||
1Mining and Metallurgical Engineering Department, Assiut University, Assiut 71516, Egypt | ||||
2Mechanical Engineering Department, Faculty of Engineering, Majmaah University ,Saudi Arabia | ||||
Abstract | ||||
Wear particles produced by vibratory cavitation erosion tests on 1045 carbon steels in three different corrosive media: distilled water, tap water and 3 % NaCl water were analyzed. Scanning electron microscope (SEM) of wear particles were acquired, forming database for further analysis. This study shows that there is no remarkable difference in the particle size with test solution. However, the frequency distribution of particle sizes differed with the test solution. It is the highest at small sizes for tap and distilled water. While for salt water, it is the highest for the larger sizes (larger than 50 µm). All the particles, irrespective of solution, manifested similar morphological features such as lamellar shape, crack propagation on the particle surface and secondary cracks. This indicates that the particles are produced by a single mechanism, namely, fatigue. With regard to the role of corrosion in the development of cavitation erosion, it was most pronounced in the case of salt water. It was found that dissolution of ferrite acts as areas of stress concentration which give rise to crack initiations. This gives a strong impetus to the crack initiations. | ||||
Keywords | ||||
Cavitation erosion-corrosion; particle morphology; fatigue; carbon steel; corrosive waters | ||||
Statistics Article View: 77 PDF Download: 207 |
||||