VOLTAGE AND CURRENT HARMONIC SUPPRESSION BY SHUNT ACTIVE FILTER FEEDING DC LOAD ON DC LINK | ||||
| JES. Journal of Engineering Sciences | ||||
| Article 13, Volume 41, No 2, March and April 2013, Page 558-576 PDF (520.45 K) | ||||
| Document Type: Research Paper | ||||
| DOI: 10.21608/jesaun.2013.114749 | ||||
 View on SCiNiTO | ||||
| Authors | ||||
Gaber El-Saady1; Ashraf Hemeida2; M. Nasrallah  3
| ||||
| 1Power Engineering and Machines Department, Faculty of Engineering, Assiut University, Asyut, Egypt | ||||
| 2Electrical Engineering Department, Faculty of Energy Engineering, Aswan University, Aswan, 81528, Egypt | ||||
| 3Power Engineering and Machines Dep., Faculty of Eng, South Valley University, Qena, Egypt | ||||
| Abstract | ||||
| Shunt active filter is used for suppression of current harmonics of nonlinear load to adjust total harmonics distortion (THD) of terminal voltage to the IEEE standards to improve the power quality. A specific control strategy which uses voltage detection of harmonic to reduce harmonics distortion in the waveforms of source current and terminal voltage resulting from distorted source and nonlinear load (together or separately) is applied. Moreover , the proposed control strategy is used to adjust the terminal voltage without effect on the other loads connected to the same common coupling point. This is used to reduce the voltage drop caused by current source by reducing harmonics on distribution power system to improve the power quality. The effectiveness and reliability of the specific control strategy used to control the shunt active filter has been verified by simulation results. In addition, theoretical analysis is presented to confirm the validity of the simulation results | ||||
| Keywords | ||||
| Active filter; power quality; harmonic suppression in distribution power system | ||||
|
Statistics Article View: 86 PDF Download: 307 |
||||
