EFFECT OF AGGREGATE GRADATION AND TYPE ON HOT ASPHALT CONCRETE MIX PROPERTIES | ||||
| JES. Journal of Engineering Sciences | ||||
| Article 1, Volume 42, No 3, May and June 2014, Page 567-574 PDF (151.71 K) | ||||
| Document Type: Research Paper | ||||
| DOI: 10.21608/jesaun.2014.115005 | ||||
 View on SCiNiTO | ||||
| Author | ||||
| Afaf A. H. M. | ||||
| Civil Eng. Dep., Faculty of Eng., Minia University | ||||
| Abstract | ||||
| Mineral aggregates make up 90 to 96% of a HMA mix by weight or approximately 75 to 85% by volume. The properties of the mineral aggregates have significant affects in performance of our roadways which offers the possibility of investment in these properties towards resisting different ranges of external applied loads and environmental conditions. Therefore, aggregate characteristics deeply affect the performance of asphalt pavements. Gradation is one of the important characteristics of aggregates affecting permanent deformation of hot mix asphalt. The objective of this research is to investigate the impact of aggregate gradation variations on various properties of asphalt concrete mixtures. Fine, medium and coarse gradation mixtures for different aggregate types were tested to investigate the effects of variation in the aggregate types and gradation on mix properties. The asphalt contents of the mixes were maintained at the job mix design contents. Properties investigated were, Marshall Stability, Marshall Flow, unit weight, air voids, and voids in mineral aggregate. Analysis of the considering different aggregate type data revealed that the finecoarse and coarse-fine gradation variations had the greatest impact on mix. The research program concentrated on the Marshall Design criteria for bituminous mixes. The results indicated that optimum asphalt content (OAC) is different due to aggregate type A coarse grading with 25 mm maximum size is found to give the most satisfactory result from the stand point of stability, stiffness, and voids characteristics. Test results reveal that the bituminous concrete with WCA can give satisfactory results when they are constructed using coarse gradation. | ||||
| Keywords | ||||
| Bituminous concrete; Gradation of aggregate; Marshall Design criteria | ||||
|
Statistics Article View: 123 PDF Download: 993 |
||||
