Heat and Mass Transfer in a Direct Evaporative Cooler Using New Material.
Saafan, M., Fouda, A., Elbaz, A. (2020). Heat and Mass Transfer in a Direct Evaporative Cooler Using New Material.. EKB Journal Management System, 38(1), 117-136. doi: 10.21608/bfemu.2020.116709
Mohamed Saafan; A. Fouda; A. Elbaz. "Heat and Mass Transfer in a Direct Evaporative Cooler Using New Material.". EKB Journal Management System, 38, 1, 2020, 117-136. doi: 10.21608/bfemu.2020.116709
Saafan, M., Fouda, A., Elbaz, A. (2020). 'Heat and Mass Transfer in a Direct Evaporative Cooler Using New Material.', EKB Journal Management System, 38(1), pp. 117-136. doi: 10.21608/bfemu.2020.116709
Saafan, M., Fouda, A., Elbaz, A. Heat and Mass Transfer in a Direct Evaporative Cooler Using New Material.. EKB Journal Management System, 2020; 38(1): 117-136. doi: 10.21608/bfemu.2020.116709

Heat and Mass Transfer in a Direct Evaporative Cooler Using New Material.

MEJ- Mansoura Engineering Journal
Article 14, Volume 38, Issue 1, March 2013, Page 117-136  XML PDF (22.29 MB)
Document Type: Research Studies
DOI: 10.21608/bfemu.2020.116709
View on SCiNiTO View on SCiNiTO
Authors
Mohamed Saafan1; A. Fouda email 2; A. Elbaz2
1Professor of Mechanical Power Engineering., Faculty of Engineering., El-Mansoura University., Mansoura., Egypt.
2Production Engineering and Mechanical Design Department., Faculty of Engineering., El-Mansoura University., Mansoura., Egypt.
Abstract
This paper presents the performance analysis of a new evaporative cooling pad material ''Luffa'', or luffa, sponges which are produced from long, thin gourds and are much harder and more abrasive than sea sponges. Most often, luffa sponges are used for scrubbing and exfoliating dead skin. Often seen for sale in stores in the form of back brushes exfoliating mitts, luffa sponges also make ideal scrubbers for pots, pans and surfaces, such as the counter tops. The luffa sponges is an amazing versatile, no-fuss plant that is relatively easy to grow in warm climates [1]. A test tunnel is constructed for this particular work and the behavior of this new evaporative cooling pad material is analyzed while changing of three parameters. Air velocity, water flow rate and the bad thickness. Inlet and outlet air characteristics are recorded with time and transit variation of thermo-physical properties of air is then evaluated from the measured data and heat and mass transfer equations. Cooling effectiveness, heat transfer coefficient, mass transfer coefficient and accordingly Nusslet and sSherwod numbers are obtained and compared each time. This new bad materials offers the lowest pressure drop among other materials (<10N/m2) with high effectiveness(94%). Because of better performance, lower costs and easy availability of this new bad material. Using it as wetted media may enhance the scope of using this material in domestic and commerical evaporative cooling systems for sustainable development.
Statistics
Article View: 157
PDF Download: 220