FABRICATION AND TEST OF A TRACTOR-FRONT-MOUNTED TWO-ROW SUGARCANE HARVESTER | ||||
| Misr Journal of Agricultural Engineering | ||||
| Article 2, Volume 37, Issue 4, October 2020, Page 331-344 PDF (1.26 MB) | ||||
| Document Type: Original Article | ||||
| DOI: 10.21608/mjae.2020.47259.1013 | ||||
 View on SCiNiTO | ||||
| Authors | ||||
| Abdallah M. Zein El-den1; Saad F. Ahmed1; Waleed M. Hanafy2; Abdallah E. Elwakeel* 3 | ||||
| 1Prof., of Ag. Eng., Fac. of Ag., Alexandria U., Alexandria, Alshatby, Egypt. | ||||
| 2Assist. Prof., of Ag. Eng., Fac. of Ag., Aswan U., Aswan, Egypt. | ||||
| 3Assist. Lect., of Ag. Eng., Fac. of Ag., Aswan U. Aswan, Egypt. | ||||
| Abstract | ||||
| A tractor-front mounted sugarcane harvester was fabricated and tested. The machine parts were designed using “SolidWorks” software. The machine was then manufacturing and constructed by using the low cost material available in local market. Main components of this machine are machine frame, cutter head, power transmission system, and power supply. Results of the tests showed that the effective field capacity ranged from 1.16 to 1.3 fed/h, and increased with an increase in row spacing and forward speed. In the high crop density fields, the cutter head efficiency averaged 100 %. It, however, increased with a decrease in cutting height and also, increased with an increase in row spacing and number of knives. The throughput capacity increased from 42.9 to 79.02 t/h as the row spacing increased from 71 to 88.75 cm and the maximum total operating costs are 120 EGP/h (98.5 and 92.3 EGP/Fed) depending on the power requirements. | ||||
| Keywords | ||||
| Sugarcane Harvesting Systems; Mechanized Systems; Sugar Cane Combine; Tractor Mounted Cutters | ||||
| References | ||||
|
Abd-El Mawla, H. A., et al. (2014). “Field evaluation and crop conditions related to sugar cane mechanical harvesting”, Egypt. J. Agric. Res., 92(1), 257: 271.
Bastian J. and Shridar, B. (2014). “Investigation on Mechanical Properties of Sugarcane Stalks for the Development of a Whole Cane Combine Harvester”, Indian journal of applied research, 4 (9), pp. 1-9.
Debeer, A. G. (1974). “An assessment of the options for mechanical harvesting of sugarcane in South Africa”, Proceedings of the South African Sugar Technologists' Association, pp. 111-112.
Hamada, Y. M. (2011). “Water Resources Reallocation in Upper and Middle Egypt”, EWRA European Water, EW Publications, 33: 33-44.
Rohit J. M., et al. (2015). “Design and Fabrication of Small Scale Sugarcane Harvester”, Journal of Mechanical and Civil Engineering, 2(3): 1 – 9. O
Siddaling, S. and Ravaikiran, B. S. (2015). “Design and Fabrication of Small Scale Sugarcane Harvesting Machine”, International Journal of Engineering Research and General Science, 3(4), pp. 293-298. | ||||
|
Statistics Article View: 483 PDF Download: 886 |
||||
