Analysis of Practical Parameters Required for Power Line Carrier (PLC) System Design. | ||||
MEJ- Mansoura Engineering Journal | ||||
Article 15, Volume 35, Issue 1, March 2010, Page 117-128 PDF (991.2 K) | ||||
Document Type: Research Studies | ||||
DOI: 10.21608/bfemu.2020.123652 | ||||
View on SCiNiTO | ||||
Authors | ||||
El-H. Abd-Rabol* 1; Magdi Mohamed Ali El-Saadawi2; A. Hassan3; A. Al-Sarraf4 | ||||
1Dept. of Electrical Engineering, Faculty of Engineering, Mansoura University,Mansoura, Egypt | ||||
2Associate Professor., Electrical Power Engineering Department., Faculty of Engineering., El-Mansoura University., Mansoura., Egypt. | ||||
3Electrical Engineering Department., Faculty of Engineering., El-Mansoura University., Mansoura., Egypt. | ||||
4Electrical Power Engineering Department., Faculty of Engineering., El-Mansoura University., Mansoura., Egypt. | ||||
Abstract | ||||
The increased demands of communications make the power supply on a way to migrate from a pure power distribution system to a multipurpose medium delivering power, voice and various data services. Transmission and distribution lines are considered as communication channels. A number of practical parameters have to be studied for appropriate design of any communications system. The main parameters of interest of the power lines as a data communications channel are: additive noise characteristics, modulation techniques and signal attenuation over the transmission line. This paper presents an analytical study of the main parameters of PLC system. A Matlab computer program is developed to analyze these parameters and can be used for designing PLC channels. The developed computer program is helpful in comparing different modulation methods and can be used to simulate different additive noise affecting the PLC channel and consequently design the appropriate filter | ||||
Keywords | ||||
Power line carrier; Noise; Modulation; Attenuation; PLC transfer model | ||||
Statistics Article View: 103 PDF Download: 171 |
||||