Fault Diagnosis in Machining Based on Statistical Process Control.
El-Baz, M. (2020). Fault Diagnosis in Machining Based on Statistical Process Control.. EKB Journal Management System, 35(1), 45-54. doi: 10.21608/bfemu.2020.124667
M. El-Baz. "Fault Diagnosis in Machining Based on Statistical Process Control.". EKB Journal Management System, 35, 1, 2020, 45-54. doi: 10.21608/bfemu.2020.124667
El-Baz, M. (2020). 'Fault Diagnosis in Machining Based on Statistical Process Control.', EKB Journal Management System, 35(1), pp. 45-54. doi: 10.21608/bfemu.2020.124667
El-Baz, M. Fault Diagnosis in Machining Based on Statistical Process Control.. EKB Journal Management System, 2020; 35(1): 45-54. doi: 10.21608/bfemu.2020.124667

Fault Diagnosis in Machining Based on Statistical Process Control.

MEJ- Mansoura Engineering Journal
Article 26, Volume 35, Issue 1, March 2010, Page 45-54  XML PDF (828.94 K)
Document Type: Research Studies
DOI: 10.21608/bfemu.2020.124667
View on SCiNiTO View on SCiNiTO
Author
M. El-Baz email
Industrial Engineering Department., Faculty of Engineering., Zagazig University., Zagazig., Egypt.
Abstract
In this paper, a fault diagnosis method based on statistical process control charts is proposed. The approach uses the knowledge extractions obtained from statistical process control charts and then extracts a set of minimal diagnostic rules by the experts in the field. The diagnosis performance of the proposed method is demonstrated using an experimental study. By means of the extracted knowledge, the machining process failures, and related rapid diagnosis can be identified. A practical system is presented to illustrate the efficiency and effectiveness of the proposed method. 
Keywords
Statistical process control; Machinability; Fault diagnosis
Statistics
Article View: 85
PDF Download: 130