Prediction of Film Cooling Effectiveness by a Row of Moles over a Flat Surface. | ||||
MEJ- Mansoura Engineering Journal | ||||
Article 1, Volume 19, Issue 3, September 1994, Page 27-40 PDF (780.77 K) | ||||
Document Type: Research Studies | ||||
DOI: 10.21608/bfemu.2021.163753 | ||||
View on SCiNiTO | ||||
Authors | ||||
Handry Ammari1; N. Hay* 2 | ||||
1Mechanical Engineering Department., Mu'tah University., Jordan. | ||||
2Mechanical Engineering Department., University of Nottingham., UK. | ||||
Abstract | ||||
The present paper describes a numerical procedure and its capability for calculating the film cooling effectiveness by injection from a single transverse row of discrete holes over a flat surface. The three-dimensional calculation procedure takes into account the elliptic nature of the flow after the injection. The effects of turbulence are simulated through the implementation of the standard k-ε turbulence model. Results are given for; two injection angles of 35° and 90o, spacing between the holes of 3 hole diameters, coolant-to-mainstream density ratios of 1.0 and 2.0, and blowing rates from 0.5-2.0. The predicted cooling effectiveness is compared with some available experimental data and shows an overall performance of reasonably good agreement. | ||||
Statistics Article View: 56 PDF Download: 145 |
||||