Modeling and Simulation for Multivariable Chemical System in Semadco Urea-Plant. | ||||
| MEJ- Mansoura Engineering Journal | ||||
| Article 6, Volume 16, Issue 1, May 1991, Page 80-88 PDF (69.77 K) | ||||
| Document Type: Research Studies | ||||
| DOI: 10.21608/bfemu.2021.169278 | ||||
 View on SCiNiTO | ||||
| Authors | ||||
| K. M. Soliman* 1; N. Mekkawy2 | ||||
| 1Automatic Control & Computers Department., Faculty of Engineering., El- Mansoura University., Mansoura., Egypt. | ||||
| 2Process control & Inst. Dept., Ammonía plant., Semadco, Talkha. | ||||
| Abstract | ||||
| For target or stabilizing the operation of ammonia converter R-107 is Semadco CTALKHA II Fertilizer Company that is by designing appropriate control system for the "HP BFW heater E-127" CHigh Pressure Boiler Feed Water heater) which governs the system inlet temperature; It is very important to construct a mathematical model which simulates perfectly the practical system construction and operation, Such a model is not clearly and accurately presented in references. So; this work deals with formulating and constructing suitable mathematical model for this E -127 heater. The modeling procedure is based on dividing the chemical system into subsystems coupled through boundary conditions. The suggested mathematical model is tested numerically by computing the system open loop performances, which are then compared with the recorded experimental performances from the field. The results obtained show good agreement between both of the suggested model and the physical system. | ||||
|
Statistics Article View: 83 PDF Download: 125 |
||||
