A Study on Catalyst Entrainment from the Ethylene Oxychlorination Fluidized Bed Reactor | ||||
| Journal of Petroleum and Mining Engineering | ||||
| Article 3, Volume 23, Issue 1, June 2021, Page 12-16 PDF (837.76 K) | ||||
| Document Type: Full-length article | ||||
| DOI: 10.21608/jpme.2021.50633.1060 | ||||
 View on SCiNiTO | ||||
| Authors | ||||
Rehab El-Maghraby  ; Alaa youssef; Abeer Shoaib
| ||||
| Petroleum Refinery and Petrochemical engineering Department, Suez University, Egypt | ||||
| Abstract | ||||
| During the production of ethylene dichloride, the entrainment of catalyst particles out of the bed is considered a problematic issue that affects the conversion of the hydrogen dichloride and causes repeated unit shut down. In this study the effect of the various operating conditions was measured; the fluidizing gas flowrate, the bed parameters, the reaction conditions, and the static design parameters such as the internal orifice diameter of the distributer. A simulation model was built using Mat Lab and Aspen Plus software. The results from both models were compared with the sample analysis data obtained from the laboratory. It was found that when the entering gas flow rate reached 2570.4 m3/hr, the bubble diameter of the fluidizing gas reached maximum value, and hence, the entrainment of catalyst particles was at the lowest quantity of about 8.2 Kg/m2.s. In addition, it was found that as the pressure drop through the orifice of the distributer decrease the entrainment of solids increase until an orifice diameter of 1 cm is reached, hence, the lowest rate of entrainment of catalyst particles is achieved. at such conditions the highest conversion of ethylene and HCL into Ethylene dichloride could be reached. | ||||
| Keywords | ||||
| Entrainment; HCL conversion; bubble diameter; fluidization; orifice diameter | ||||
|
Statistics Article View: 495 PDF Download: 707 |
||||
