Design and Implementation of a Stabilizing Network for Reluctance Motors. | ||||
| MEJ- Mansoura Engineering Journal | ||||
| Article 8, Volume 14, Issue 1, June 1989, Page 10-21 PDF (248.72 K) | ||||
| Document Type: Research Studies | ||||
| DOI: 10.21608/bfemu.2021.171830 | ||||
 View on SCiNiTO | ||||
| Authors | ||||
| S. M. Osheba1; F. M. Abdel Kader* 2 | ||||
| 1Electrical Engineering Department., Faculty of Engineering., Menoufia University., Shebin El-Kom., Egypt. | ||||
| 2Electrical Power Engineering., Faculty of Engineering., Suez Canal University., Port Said., Egypt. | ||||
| Abstract | ||||
| This paper presents a method for stabilizing the low-frequency oscillations in reluctance motors. This method is based on modulating the input voltage by a feedback signal. This signal is obtained by using a speed feed back through a lead/lag compensating network. The parameters of this network are designed using an eigenvalues shift technique and the values which give maximum damping were determined. The obtained results illustrate a significant increase in damping and indicates that substantial improvement in reluctance motor performance can be achieved by using a simple electric circuit. | ||||
|
Statistics Article View: 57 PDF Download: 140 |
||||
