Different Materials Consisting the Interference Shrink-Fitted Joints. | ||||
| MEJ- Mansoura Engineering Journal | ||||
| Article 9, Volume 13, Issue 2, December 1988, Page 1-16 PDF (1.47 MB) | ||||
| Document Type: Research Studies | ||||
| DOI: 10.21608/bfemu.2021.173224 | ||||
 View on SCiNiTO | ||||
| Authors | ||||
| Ibrahim Elewa Ammar* 1; Ahmed Abd El-Shafi2 | ||||
| 1Assistant Professor., Industrial Production and Engineering Department., Faculty of Engineering., El-Mansoura University., Mansoura., Egypt. | ||||
| 2Assistant Professor., Industrial Production Engineering Department., Faculty of Engineering., El-Mansoura University., Mansoura., Egypt. | ||||
| Abstract | ||||
| The materials used for the most previous work to investigate the characteristics of shrink-fitted joints are a commercially available mild steel. Shrink-fitted joints are produced using a much wider material range which can include nonferrous materials. The paper at hand is concerned with the effect of changing material type and the use of differeing material combinations on the joint holding load. A theoretical approach is adopted to evaluate the holding load and stress induced between the two mating surfaces of the joint. Also, an experimental work is designed to investigate the effects of some parameters on the joint holding load i.e. the surface roughness and the interference value. The different materials used to produce the two members of the joints are, Mild Steel, Brass, Aluminium, and Bronze Phosporic Copper. | ||||
|
Statistics Article View: 71 PDF Download: 143 |
||||
