Modelling and Experimental Validation of Turbulent Flame Propagation is Spark Ignition Engines.
Abdel-Salam, H., Shoppard, C., Awad, M., Desoky, A. (2021). Modelling and Experimental Validation of Turbulent Flame Propagation is Spark Ignition Engines.. EKB Journal Management System, 20(3), 19-35. doi: 10.21608/bfemu.2021.192294
H. A. Abdel-Salam; C. G. W. Shoppard; M. M. Awad; A. R. A. Desoky. "Modelling and Experimental Validation of Turbulent Flame Propagation is Spark Ignition Engines.". EKB Journal Management System, 20, 3, 2021, 19-35. doi: 10.21608/bfemu.2021.192294
Abdel-Salam, H., Shoppard, C., Awad, M., Desoky, A. (2021). 'Modelling and Experimental Validation of Turbulent Flame Propagation is Spark Ignition Engines.', EKB Journal Management System, 20(3), pp. 19-35. doi: 10.21608/bfemu.2021.192294
Abdel-Salam, H., Shoppard, C., Awad, M., Desoky, A. Modelling and Experimental Validation of Turbulent Flame Propagation is Spark Ignition Engines.. EKB Journal Management System, 2021; 20(3): 19-35. doi: 10.21608/bfemu.2021.192294

Modelling and Experimental Validation of Turbulent Flame Propagation is Spark Ignition Engines.

MEJ- Mansoura Engineering Journal
Article 3, Volume 20, Issue 3, September 1995, Page 19-35  XML PDF (1.25 MB)
Document Type: Research Studies
DOI: 10.21608/bfemu.2021.192294
View on SCiNiTO View on SCiNiTO
Authors
H. A. Abdel-Salam* 1; C. G. W. Shoppard2; M. M. Awad3; A. R. A. Desoky4
1Assistant Professor., Mechanical power Engineering Department., Faculty of Engineering., El-Mansoura University., Mansoura., Egypt.
2Professor., Mechanical Power Engineering Department., University of Leeds., England.
3Professor and Head of Mechanical Power Engineering Department., Faculty of Engineering., El-Mansoura University., Mansoura., Egypt.
4Professor., Mechanical Power Engineering Department., Faculty of Engineering., Mansoura University., Mansoura., Egypt.
Abstract
This work is concciped with modeling and experimental validations of turbulent flame propagation in spark ignition engines. An existing engine cycle model, developed in leads for single chamber spark ignition engines, has been modified in order to obtain more realistic model predictions. The most significant improvement involved the incorporation of a sub-model for blow by and piston top land crevice flow.
To optimize and then verify the modified model predictions, the model was initially applied to data derived from experiments using an optically accessed two stroke spark ignition engine. The modified model was optimized an engine cycle at the running conditions compression ratio 8.3, equivalence ratio 1.0, engine speed 1100 rpm and intake manifold pressure of 0.85 bar. Thereafter, its predictive performance was verified for other cycles at varied engine operating conditions.
The inclusion of the blowby routine was shown to greatly improve the predictions of the model, compared with the experimental data. Inclusion of hlowby is particularly important is modelling ported two strake engines, due to the eefficiency of the piston rings early is the compression stroke.
Keywords
St engine cycle model; Turbulent combustion in spark ignition engines
Statistics
Article View: 63
PDF Download: 98