Comparison in Vitro Between Three-Dimensionally Printed, Milled Cad-Cam and Manually Fabricated Interim Crown Materials | ||||
| Al-Azhar Assiut Dental Journal | ||||
| Article 5, Volume 4, Issue 2, October 2021, Page 141-150 PDF (1.44 MB) | ||||
| Document Type: Original Article | ||||
| DOI: 10.21608/aadj.2021.208206 | ||||
 View on SCiNiTO | ||||
| Author | ||||
| Raafat A. Tammam* | ||||
| Department of Fixed Prosthodontics, Faculty of Dentistry Assiut University, Egypt. | ||||
| Abstract | ||||
| Aim: The marginal and internal fit, fracture strength, and mode of failure of 3rd printed CAD/CAM provisional crowns were compared to those of direct provisional crowns. Subjects and Methods; Following tooth preparation guidelines upper right first premolar Farasco tooth. 3rd printed Polyphenylene sulfone (PPSU), milled CADCAM Polyetheretherketone (PEEK) and ProtempTM4 manually fabricated were the materials tested (control group). The crowns were divided into three groups (n=20): Groups 1, 2, and 3: Each crown was examined for marginal and internal fit, fracture strength, and failure mode. In a universal test machine, the maximum force at fracture (Fmax) was measured, and the mode of failure was reported at 0.5 mm/min. ANOVA, chi-squared test, and Tukey’s tests (p 0.05). Results: the average marginal gap of PEEK(Polyetheretherketone) CAD-CAM was less than the 3rd printed PPSU (Polyphenylene sulfone) and direct fabrication Protemp™4, PPSU 80.64±8.34 µm, PEEK 60.64±9.54 µm, and Protemp4 120.64±32.34 µm. This indicated a statistically significant difference in the marginal gap distances between all groups (p < 0.001). The average internal gap value for each group was: PPSU 155.32±20.56 µm, PEEK 123.45±16.11 µm, and Protemp™4 260.34±34.45 µm. There was a statistically significant difference in fracture strength between all classes. (p < 0.001). Each group’s average fracture strength was: PPSU 657.43±23.43 N, PEEK 870.45±18.87 N, and Protemp™4 427.34±25.43 N. Conclusion. CAD/CAM PEEK temporary crowns and the 3rd printed PPSU material exhibited significantly higher fracture strength and less marginal and internal gap measurements than conventionally fabricated Protemp™ 4 resins after the aging regimen. | ||||
| Keywords | ||||
| Temporary dental restoration; Dental marginal adaptation; CADCAM; 3rd printed temporary crown; Dental prosthesis | ||||
|
Statistics Article View: 176 PDF Download: 467 |
||||
