Experimental Study of Static Deflection and Natural Frequency of Cu-Al Combined Rods | ||||
| Egyptian Journal of Chemistry | ||||
| Article 21, Volume 65, Issue 11, November 2022, Page 225-234 PDF (993.71 K) | ||||
| Document Type: Original Article | ||||
| DOI: 10.21608/ejchem.2022.116235.5339 | ||||
 View on SCiNiTO | ||||
| Authors | ||||
Mohammed Ali Diwan1; Abbas Ali Diwan   2; luay Sadiq alansari3
| ||||
| 1Engineering Technical College, Al-Furat Al-Awsat Technical University, Kufa, Iraq | ||||
| 2Nanotechnology and Advance Material Research Unit, Faculty of Engineering, University of Kufa, Najaf, Iraq | ||||
| 3Department of mechanical Engineering, Faculty of Engineering, University of Kufa, Iraq | ||||
| Abstract | ||||
| In this research, the static deflection and the natural frequency of the aluminum-copper combined rods with a fixed length of 60 cm and with different lengths of its component parts were experimentally studied. Six rods were used, each divided into the following parts: (60 cm copper), (12cm aluminium– 48cm copper), (24cm aluminium–36cm copper), (36cm aluminium–24cm copper), (48cm aluminium–12cm copper), (60cm aluminium). The rods were fixed by a simple support at each end. The static deflection was measured by moving the digital dial gauge along the rods divisions, while fixing the load value each once. The natural frequency of each rod was measured by an oscillator device. The results showed that the static deflection of the parts made of aluminum is greater than that made of copper While the natural frequency of the rods increases with the increase in the aluminium proportion compared with copper in each rod. | ||||
| Keywords | ||||
| static deflection; cupper; Aluminum; natural frequency | ||||
|
Statistics Article View: 283 PDF Download: 126 |
||||
