Developing Controller Performance Using Model-Based Design and Rapid Controller Prototyping Techniques | ||||
International Conference on Aerospace Sciences and Aviation Technology | ||||
Article 41, Volume 13, AEROSPACE SCIENCES & AVIATION TECHNOLOGY, ASAT- 13, May 26 – 28, 2009, May 2009, Page 1-14 PDF (1.91 MB) | ||||
Document Type: Original Article | ||||
DOI: 10.21608/asat.2009.23538 | ||||
View on SCiNiTO | ||||
Authors | ||||
A. Y. Maxi1; E. Y. Akl2; S. M. Wasfy3; S. M. Sharaf4; M. I. Ghobrial5 | ||||
1Eng, Science and Technology Center of Excellency. | ||||
2Dr., Director of Technical Institute for developed Industries, El-Salam City. | ||||
3Prof. Dr., Dean, Faculty of Engineering-Helwan University. | ||||
4Prof. Dr., Head of Electrical Power Engineering Department Faculty of Engineering, Helwan University. | ||||
5Prof. Dr., Head of Mechanical Engineering Department Faculty of Engineering, Helwan University. | ||||
Abstract | ||||
Developing a controller for a mechanical conveyor mechanics is considered in this paper. The mechanical conveyor under study is divided into two subsystems. The first is a rotating mass and the second is a chain conveyor. Each of these subsystems can operate independently from the other. Two identical servo motors supported with two similar drivers are used to drive this system. A controller is designed to achieve significant response of the system and to respond to the user demands for different modes of operations. Also, the controller achieves the required profile of the output speed for the motors. In addition, perfected following of the motors speed with the required speed trajectory for each subsystem must be ensured. This paper describes the integration among Computer Aided Design and Computer Aided Engineering CAD/CAE software, real time testing and simulation incorporated with rapid controller prototyping techniques can be used to perform controller design for complete mechatronic machine. The article and experimental results to satisfy the improved performance of the system are included in this paper. | ||||
Keywords | ||||
Co-Simulation; Real-time Simulation; Rapid Control Prototyping; xPC Target Box; PI controller; Hardware in the loop | ||||
Statistics Article View: 113 PDF Download: 119 |
||||