NUCLEATE POOL BOILING FROM PLAIN AND ENHANCED SINGLE TUBE TO R12 AND R134a FOR AIR-CONDITIONING EVAPORATORS
Aziz, M., Sayed, S., El Refai, A. (1999). NUCLEATE POOL BOILING FROM PLAIN AND ENHANCED SINGLE TUBE TO R12 AND R134a FOR AIR-CONDITIONING EVAPORATORS. EKB Journal Management System, 8(ASAT Conference, 4-6 May 1999), 1-16. doi: 10.21608/asat.1999.24910
Mohammed A. Aziz; Sayed A. Sayed; A. El Refai. "NUCLEATE POOL BOILING FROM PLAIN AND ENHANCED SINGLE TUBE TO R12 AND R134a FOR AIR-CONDITIONING EVAPORATORS". EKB Journal Management System, 8, ASAT Conference, 4-6 May 1999, 1999, 1-16. doi: 10.21608/asat.1999.24910
Aziz, M., Sayed, S., El Refai, A. (1999). 'NUCLEATE POOL BOILING FROM PLAIN AND ENHANCED SINGLE TUBE TO R12 AND R134a FOR AIR-CONDITIONING EVAPORATORS', EKB Journal Management System, 8(ASAT Conference, 4-6 May 1999), pp. 1-16. doi: 10.21608/asat.1999.24910
Aziz, M., Sayed, S., El Refai, A. NUCLEATE POOL BOILING FROM PLAIN AND ENHANCED SINGLE TUBE TO R12 AND R134a FOR AIR-CONDITIONING EVAPORATORS. EKB Journal Management System, 1999; 8(ASAT Conference, 4-6 May 1999): 1-16. doi: 10.21608/asat.1999.24910

NUCLEATE POOL BOILING FROM PLAIN AND ENHANCED SINGLE TUBE TO R12 AND R134a FOR AIR-CONDITIONING EVAPORATORS

International Conference on Aerospace Sciences and Aviation Technology
Article 31, Volume 8, ASAT Conference, 4-6 May 1999, May 1999, Page 1-16  XML PDF (3.14 MB)
Document Type: Original Article
DOI: 10.21608/asat.1999.24910
View on SCiNiTO View on SCiNiTO
Authors
Mohammed A. Aziz1, 2; Sayed A. Sayed3, 2; A. El Refai4, 2
1Assoc. Prof. Dpt. of Mech. Power Zagazig University, Zagazig Egypt+
2Department of Mechanical Power Engineering Faculty of Engineering, Zagazig University Zagazig, Egypt.
3Prof. Dpt. Of Mech. Power Zagazig University, Zagazig Egypt+
4Lect. Dpt. Of Mech. Power Zagazig University, Zagazig Egypt+
Abstract
Measurements of pool boiling heat transfer coefficients in pure R12 and R134a are reported for a plain tube (FYI) and three enhanced tubes: (Screen Matrix tube, (SM) and two integral finned tubes: Radial (RF) and longitudinal LF). The data were taken at saturation temperatures of -5, and 5 , and heat flux range from 2 x 103 to 104 W/m2. All enhanced tubes provide higher boiling coefficients than the plain tube does. The slopes of the boiling coefficient vs the heat flux curves for enhanced tubes are smaller than those for the plain tube, indicating the dominating effect of enhanced surfaces conditions. The mechanism describing the generation, growth and separation of bubbles for tested enhanced tubes was elaborated . The highest boiling coefficient was found to belong to the screen matrix tube , having the highest nucleation sites density. Additional achievement was observed when R134a was tested at the considered operating condition. Two correlations for predicting the boiling coefficients from the present considered surfaces were developed with satisfactory accuracy for the design of refrigerant flooded evaporators.
Keywords
Pool Boiling; R12; R134a; Enhanced Surface
Statistics
Article View: 113
PDF Download: 196