PROPOSED CORRECTION FACTORS for PUNCHING SHEAR CAPACITY of RC FLAT SLABS with SHEAR REINFORCEMENT | ||||
| Engineering Research Journal (Shoubra) | ||||
| Volume 51, Issue 4, October 2022, Page 8-18 PDF (949.65 K) | ||||
| Document Type: Research articles | ||||
| DOI: 10.21608/erjsh.2022.151469.1065 | ||||
 View on SCiNiTO | ||||
| Authors | ||||
YAHYA ABD ELMOEN ABO ELGHIT  1; Ahmed Abd El Fattah Mahmoud 2; Osama omar El-Mahdy 3; Ahmed Mohmed salaheldin4
| ||||
| 1Faculty of Engineering at Shoubra, Benha University, Cairo, Egypt. | ||||
| 2DepartmeFaculty of Engineering at Shoubra, Benha University, Cairo, Egypt nt of Civil Engineering-Shoubra- Benha University | ||||
| 3Professor of Structural Analysis, Civil Engineering Department, Faculty of Engineering at Shoubra, Banha University. | ||||
| 4Assistant Prof., Faculty of Engineering at Shoubra, Benha University, Cairo, Egypt | ||||
| Abstract | ||||
| Punching shear is the main problem facing reinforced concrete (RC) flat slabs. There are many studies to investigate the punching shear of flat slabs in the normal cases, while there are very few studies that investigate circular flat slabs supported on circular columns. Therefore, this paper experimentally investigates the effect of: (1) Steel shear studs; (2) Steel stirrups; (3) Main reinforcement details and (4) Shear reinforcement arrangement on punching shear resistance of circular RC flat slabs. The experimental results by the authors were compared with the numerical results using ANSYS V. 15, the analytical results using ACI 318-19 [2] and ECP 203-2020 [6]. The obtained results show that punching shear strength increased when using steel shear reinforcement (studs and stirrups) by 9% to 57%. Toughness and displacement ductility improved by 31% to 333% and 85 to 121%, respectively. Both ECP 203-2020 and ACI 318-2019 codes are overestimated in calculating the ultimate failure load for the range of the studied variables in this research and not in general. | ||||
| Keywords | ||||
| Correction factors; Punching shear; Circular Flat slabs; Circular columns; Shear reinforcement | ||||
|
Statistics Article View: 269 PDF Download: 357 |
||||
