EXPERIMENTAL INVESTIGATION OF THE EFFECT OF THE IMPELLER BLADE EXIT CUT ON THE PERFORMANCE OF A RADIAL COMPRESSOR
SAAD ELDIN, K., ELZAHABY, A., SALEH, I., ELSIBAIE, A., ELFEKEY, S. (1993). EXPERIMENTAL INVESTIGATION OF THE EFFECT OF THE IMPELLER BLADE EXIT CUT ON THE PERFORMANCE OF A RADIAL COMPRESSOR. EKB Journal Management System, 5(ASAT CONFERENCE 4 - 6 May 1993, CAIRO), 77-87. doi: 10.21608/asat.1993.25604
K. SAAD ELDIN; A. ELZAHABY; I. SALEH; A. ELSIBAIE; S. ELFEKEY. "EXPERIMENTAL INVESTIGATION OF THE EFFECT OF THE IMPELLER BLADE EXIT CUT ON THE PERFORMANCE OF A RADIAL COMPRESSOR". EKB Journal Management System, 5, ASAT CONFERENCE 4 - 6 May 1993, CAIRO, 1993, 77-87. doi: 10.21608/asat.1993.25604
SAAD ELDIN, K., ELZAHABY, A., SALEH, I., ELSIBAIE, A., ELFEKEY, S. (1993). 'EXPERIMENTAL INVESTIGATION OF THE EFFECT OF THE IMPELLER BLADE EXIT CUT ON THE PERFORMANCE OF A RADIAL COMPRESSOR', EKB Journal Management System, 5(ASAT CONFERENCE 4 - 6 May 1993, CAIRO), pp. 77-87. doi: 10.21608/asat.1993.25604
SAAD ELDIN, K., ELZAHABY, A., SALEH, I., ELSIBAIE, A., ELFEKEY, S. EXPERIMENTAL INVESTIGATION OF THE EFFECT OF THE IMPELLER BLADE EXIT CUT ON THE PERFORMANCE OF A RADIAL COMPRESSOR. EKB Journal Management System, 1993; 5(ASAT CONFERENCE 4 - 6 May 1993, CAIRO): 77-87. doi: 10.21608/asat.1993.25604

EXPERIMENTAL INVESTIGATION OF THE EFFECT OF THE IMPELLER BLADE EXIT CUT ON THE PERFORMANCE OF A RADIAL COMPRESSOR

International Conference on Aerospace Sciences and Aviation Technology
Article 7, Volume 5, ASAT CONFERENCE 4 - 6 May 1993, CAIRO, May 1993, Page 77-87  XML PDF (2.44 MB)
Document Type: Original Article
DOI: 10.21608/asat.1993.25604
View on SCiNiTO View on SCiNiTO
Authors
K. SAAD ELDIN1; A. ELZAHABY2; I. SALEH2; A. ELSIBAIE3; S. ELFEKEY4
1Col. Dr., Tech. Research Center.
2Prof., M.T.C.
3Prof., faculty of Eng., Ain Shams University.
4Brig. Dr., M.T. Institute.
Abstract
This study deals with the experimental investigation of the radial compressor characteristics when the blade trailing edge is cut in the radial direction. Five impeller samples, of type, " HOLSET-4 ", are manufactured. One sample is used as a reference and the other 4-samples are changed, by cutting a radial length from one blade while keeping the next blade fixed. At off design speeds ,the maximum efficiency was found to be affected strongly by these cuts. The relation between the cut ratio and the maximum efficiency was reported and correlated. The corresponding mass flow rate and pressure ratio were also determined. It was found that as the cut ratio icreases the mass flow rate decreased with the increase of max. efficiency. The pressure ratio was found to change in an opposite manner to that of mass flow rate.
Statistics
Article View: 168
PDF Download: 147