WORKPIECE SHAPE ERRORS IN ELECTROCHEMICAL MACHINING | ||||
International Conference on Aerospace Sciences and Aviation Technology | ||||
Article 21, Volume 5, ASAT CONFERENCE 4 - 6 May 1993, CAIRO, May 1993, Page 253-265 PDF (2.98 MB) | ||||
Document Type: Original Article | ||||
DOI: 10.21608/asat.1993.25627 | ||||
View on SCiNiTO | ||||
Author | ||||
A. M. Abdel Mahboud | ||||
Associate Professor. Faculty of Engineering Menoufia University, SHEBIN EL KOM EGYPT. | ||||
Abstract | ||||
Experimental and analytical investigations are conducted to determine the profile change along the frontal inter- electrode gap (IEG) in the course of electrochemical machining.The inter-electrode machining parameters are described mathematically in the steady state condition and a computer program is developed to solve the obtained formulae. A comparison between theoretical and experimental results are also carried out. A discussion of certain limitations to the ECM process is presented. | ||||
Statistics Article View: 121 PDF Download: 200 |
||||