The Effect of Different Blending Ratios and Twist Factor on the Properties of Hairiness in the Yarns Produced | ||||
International Design Journal | ||||
Article 16, Volume 12, Issue 5 - Serial Number 48, September and October 2022, Page 157-164 PDF (1.07 MB) | ||||
Document Type: Original Article | ||||
DOI: 10.21608/idj.2022.260557 | ||||
View on SCiNiTO | ||||
Authors | ||||
Haba Abdel Aziz Shalaby1; Iman Ahmed Beydoun2; Shorouq Abdel Aziz Hashem Zaher3 | ||||
1Professor of Design and Head of the Department of Spinning, Weaving, and Knitting, Faculty of Applied Arts - Benha University | ||||
2Assistant Professor of Spinning, Cotton Research Institute, Agricultural Research Center | ||||
3Engineer in the textile department | ||||
Abstract | ||||
The definition of the yarn twisting process is to give the strong yarns necessary to face the stress that is exposed during Production process then textile stage, where the yarn must be produced a minimum limit of the strength of tensile even in the case of yarn used weft which is not exposed too many strains warp to the yarns which goes through many stages during production(4). The main and basic goal of the blending process is to produce yarns and fabrics with good properties that cannot be obtained using only one type of material.(5,6,7) Whenever one of the desired qualities increases by increasing the percentage of certain material in the mixture, this leads to a decrease in one of the other qualities as a result of the decrease in the ratio of the corresponding material(7). This research aims to provide the properties of the yarns produced with a fixed medium count (count30 English) and using four types of twist factors (2,5, 3, 4, 4,5) for each productive yarn .The researcher produced nine mixtures They are 100% cotton, 100% viscose, 100% polyester, 35% polyester: 65% viscose, 35% viscose: 65% polyester, 35% cotton: 65% viscose, 65% cotton: 35% viscose, 35% cotton: 65% polyester, 65% cotton: 35% polyester and a total of 36 samples and then conducted laboratory tests on those yarns to measure the property of the hairiness | ||||
Keywords | ||||
Twisting coefficient; mixing ratios; fermentation; cotton; polyester; viscose | ||||
References | ||||
Mohamed Sabry - Textile Tests - Syndicate of Applied Arts Designers -2003.
2- Mohamed Ahmed Sultan, Textile Raw Materials, Mansha’at Al Maaref - Alexandria, 1990.
3- Muhammad Ahmed Sultan, Textile Fibers, Mansha’at al-Maaref - Alexandria, 1977.
4- J.Gordon cook- Hand Book of textile fibers – Natural Fibers – 1993.
5- Vinzanekar S.G,Ajgaonkar D.B,.Talukdar M.k.and Kothawala K.C",.realisation of fiber properties into blended yarns and fabrics ,"An international textile conference (belended textiles ) India ,November 18-20 (1981).
6- Ranganathan S.R.and Vengsarker S.R",.Fibre interactions in blended yarns ," An international textile conference (belended textiles ),India ,November 18-20th,1981.
7- Duckett K.E ,.Goswami B.C,.and Ramey H.H,.J.R",.Mechanical properties of cotton /polyester yarns ,"Text .res .J.vol .49 ,1979,p.262.
8- - Goswami, B.C., Martindal, J., Scaraina F.L., ،، Textile yarns – Technology , structure and Application ’’, London,1977.
9- Hearle, J.W.S., and Groseberg, P., ‘‘ Structural Mechanics of Fibers , yarns , and Fabrics ’’ , New Yourk , 1969.
10- Zerrin-Mehmet – Textile in general ( fiber- yarn – weaving ) – T.K.A.M- Textile and clothing Research center – 1988.
11- Cotton perfected" ,-class of the mass market,America’s textile international ,May 1986 , p.24
12- Vinzanekar S.G,Ajgaonkar D.B,.Talukdar M.k.and Kothawala K.C",.realisation of fiber properties into blended yarns and fabrics ,"An international textile conference (belended textiles ) India ,November 18-20 (1981).
13- Ranganathan S.R.and Vengsarker S.R",.Fibre interactions in blended yarns ," An international textile conference (belended textiles ),India ,November 18-20th,1981.
14- Duckett K.E ,.Goswami B.C,.and Ramey H.H,.J.R",.Mechanical properties of cotton /polyester yarns ,"Text .res .J.vol .49 ,1979,p.262.
15- Hearle, J. W. S, Grosberg, P., and Backer, S., Structural Mechanics of
Fibres, Yarns, and Fabrics, Vol. 1, Chap. 3, Wiley-Interscience, New
York, 148, 1969.
16- Chattopadhyay and S. Banerjee. “The Frictional Behavior of Ring-,
Rotor-, and Friction-spun Yarn.” J. Text. Inst. 1996, 87, Part 1, No. 1, 66.
17- Barrela, A., Tura, J. M., and Vigo, J., Belts in open-end yarns: Influence of rotor diameter and statistical distribution, Text. Res. J., 6, 389–393,
1977. | ||||
Statistics Article View: 370 PDF Download: 356 |
||||