Assessment of St. St. 316L joints welded by laser beam and metal active gas MAG processes
Magdy, A., El-Shabasy, A., Hassan, H. (2020). Assessment of St. St. 316L joints welded by laser beam and metal active gas MAG processes. EKB Journal Management System, 19(19th International Conference on Applied Mechanics and Mechanical Engineering.), 1-12. doi: 10.1088/1757-899X/973/1/012027
A M Magdy; A B El-Shabasy; H A Hassan. "Assessment of St. St. 316L joints welded by laser beam and metal active gas MAG processes". EKB Journal Management System, 19, 19th International Conference on Applied Mechanics and Mechanical Engineering., 2020, 1-12. doi: 10.1088/1757-899X/973/1/012027
Magdy, A., El-Shabasy, A., Hassan, H. (2020). 'Assessment of St. St. 316L joints welded by laser beam and metal active gas MAG processes', EKB Journal Management System, 19(19th International Conference on Applied Mechanics and Mechanical Engineering.), pp. 1-12. doi: 10.1088/1757-899X/973/1/012027
Magdy, A., El-Shabasy, A., Hassan, H. Assessment of St. St. 316L joints welded by laser beam and metal active gas MAG processes. EKB Journal Management System, 2020; 19(19th International Conference on Applied Mechanics and Mechanical Engineering.): 1-12. doi: 10.1088/1757-899X/973/1/012027

Assessment of St. St. 316L joints welded by laser beam and metal active gas MAG processes

The International Conference on Applied Mechanics and Mechanical Engineering
Volume 19, 19th International Conference on Applied Mechanics and Mechanical Engineering., July 2020, Page 1-12  XML PDF (1.98 MB)
Document Type: Original Article
DOI: 10.1088/1757-899X/973/1/012027
View on SCiNiTO View on SCiNiTO
Authors
A M Magdy1; A B El-Shabasy2; H A Hassan2
1Assistant Lecturer, Ain Shams University, Faculty of Eng., Design & Prod. Eng. Dept.
2Professor, Ain Shams University, Faculty of Eng., Design & Prod. Eng. Dept.
Abstract
Study the welding of Stainless steel 316L sheet was carried out using two welding techniques, Laser beam and Metal Active Gas MIG. Strips of 1.5 mm thick were cut from the Stainless-steel sheet and then welded using nitrogen gas for shielding. Metallographic examination using optical microscopy and SEM was conducted to study the microstructure of
the welded joints. The tensile stress for joints welded by Laser beam and MAG were ranged from 386 to 632 MPa and from 126.5 to 599 MPa respectively according to the parameters of each welding techniques. The average of microhardness values measured at successive distances for joints welded by Laser beam and MAG were 265 HV and 261 HV, respectively. The obtained results were analysed and discussed based on the recent research.
Statistics
Article View: 19
PDF Download: 19