Measurements and Modelling of the Micellization of Alkyl Benzyl Dimethyl Ammonium Chloride and Cetyl Trimethyl Ammonium Chloride in Various Aqueous Media at 298.15 °K | ||||
| Egyptian Journal of Chemistry | ||||
| Volume 66, Issue 13, December 2023, Page 1415-1431 PDF (2.46 MB) | ||||
| Document Type: Original Article | ||||
| DOI: 10.21608/ejchem.2023.193054.7589 | ||||
 View on SCiNiTO | ||||
| Authors | ||||
NORELDIN ABDOLLA 1; farid El-Dossoki  2; osama Kamal Hamza 3; Essam A. Gomaa 4
| ||||
| 1Chemistry Department, Faculty of Science, Tobrouk University, Tobrouk, Libya and the current address: Chemistry Department, University of Leicester, UK, 11 Corfield Rise, Leicester, LE3 1QF | ||||
| 2Chemistry Department, Faculty of Science, Port Said University, Port Said, Egypt | ||||
| 3Egyphar company for pharmaceutical drugs, Cairo, Egypt. | ||||
| 4Chemistry Department, Faculty of Science, El-Mansoura University Egypt | ||||
| Abstract | ||||
| The critical micelle concentration (CMC) of two cationic surfactants “alkyl benzyl dimethyl ammonium chloride (BAC), and cetyl trimethyl ammonium chloride (CTAC)” in aqueous solution of different salts, cationic dye and cationic surfactant was measured experimentally at room temperatures (298.15 °K). Four methods; conductivity, refractive index, surface tension and UV spectroscopy has been used to determine the CMC values. The CMC was found to decrease as the concentration of salts increased. Also, it was found that CMC of (BAC) and (CTAC) increase in the order: pure water ˃ 0.001 M ˃ 0.01 M ˃ 0.1 M. While it increases when the methylene blue (MB) is added to the aqueous solution. The thermodynamic parameters (∆Gmic°, α and β) of the micellization processes indicated that the micellization process is going spontaneous in all cases. Different surface properties of the two cationic surfactants including excess surface concentration and minimum area per molecule were also calculated using the surface tension measurements. The Davies equation was applied to calculate the Hydrophilic-Lipophilic Balance (HLB) values of the two cationic surfactants (BAC) and (CTAC) theoretically. An important parameter (Setschenow constant) was used to describe the effect of adding salt on the micelle size and shape of surfactant in its solution. The results indicate that the order of the salt effect is inversely proportional to the order of CMC values in different salts. | ||||
| Keywords | ||||
| Conductivity; Surface tension; Refractive index; UV spectroscopy; Micellization; modelling | ||||
|
Statistics Article View: 520 PDF Download: 209 |
||||
