Thermal and Energy Efficiency of Roof Tiles Fabricated from Crushed Aluminum Slag and Kaolin Clay for Social Residential Buildings in Egypt | ||||
| Aswan University Journal of Environmental Studies | ||||
| Article 1, Volume 4, Issue 3, June 2023, Page 83-102 PDF (845.98 K) | ||||
| Document Type: Original Research | ||||
| DOI: 10.21608/aujes.2023.190141.1123 | ||||
 View on SCiNiTO | ||||
| Authors | ||||
Maggie Kamal1; Mohamed ElAttar2; Marwa El-Naggar3; Ayman Yousef4; Ayman Ragab   1
| ||||
| 1Department of Architecture Engineering, Faculty of Engineering, Aswan University, Aswan, Egypt | ||||
| 2Department of Architecture Engineering, Faculty of Engineering, British University, Cairo, Egypt | ||||
| 3Department of Mathematics and Physics Engineering, Faculty of Engineering at Mataria, Helwan University, Cairo 11718, Egypt | ||||
| 4Department of Mathematics and Physics Engineering, Faculty of Engineering at Mataria, Helwan University, Cairo 11718, Egypt | ||||
| Abstract | ||||
| In Egyptian climates, an efficient insulating system could reduce air conditioner energy demand. Building insulation, especially waste-based insulation owing to its low cost, wide availability, and treatment of waste, became interesting. Thus, this study examined the effect of roofing tile samples made from 40% waste aluminum crushed and kaolin clay with different firing temperatures (900 °C, 1000 °C, and 1100 °C) on the internal air temperature and energy needed to cool social residential buildings built without climatic considerations in Egyptian climatic regions. Design-Builder (DB) was used to simulate the study regions for environmental performance and cooling effect. The study model was validated by comparing monthly energy use data with Aswan residential unit electricity bills. Sample S2, fired at 1000 °C, exhibited the lowest thermal conductivity and saved 4.7% to 13.33% of cooling energy across all climatic regions. In hot deserts, the roof tile sample (S2) could save till 8.99% of cooling energy. Aswan, a desert city, saves the most energy despite having a slight improvement rate 8.23% compared to other cities. Finally, the study supports sustainable design in the present and future. The sustainable design could substantially lower interior thermal temperature and cooling energy. | ||||
| Keywords | ||||
| Building insulation; Design Builder; Building envelope; Cooling energy; Industrial waste | ||||
|
Statistics Article View: 951 PDF Download: 2,083 |
||||
