DEVELOPMENT OF A SMALL THRESHING MACHINE SUITABLE FOR WHEAT AND FABA BEAN CROPS | ||||
| Misr Journal of Agricultural Engineering | ||||
| Article 1, Volume 40, Issue 4, October 2023, Page 279-292 PDF (1.17 MB) | ||||
| Document Type: Original Article | ||||
| DOI: 10.21608/mjae.2023.235015.1118 | ||||
 View on SCiNiTO | ||||
| Authors | ||||
N. E. mansour  1; M. A. Aboegela2
| ||||
| 1Asist. Prof. of Ag. Eng., Nat. Res. and Ag. Eng. Dept., Fac. of Ag., Damanhour U., Egypt, | ||||
| 2Senior Res., Ag. Eng., Res. Inst. Ag. Res. Center, Dokki, Giza, Egypt. | ||||
| Abstract | ||||
| The main purpose of this research is to development and evaluates a small threshing machine to suit small spaces spread in Egypt. The threshing apparatus produced at the Tanta Engine Factory (Imagro) was developed, and its effectiveness was assessed at the Itay Al-Baroud Agricultural Research Station 2020 according to two separate experiments the studied crop. The developed machine was evaluated at four levels of drum speed (350, 400, 450 and 500 rpm with faba bean - 600, 650, 700 and 750 rpm with Wheat) and three levels of feeding rate (360, 480 and 720kg/h). The Evaluation was based on the following parameters: productivity, threshing efficiency, threshing damage, cleaning efficiency, blown seed percentage, power requirements, energy consumption and costs. The results showed that increasing the drum speed improved cleaning effectiveness. under both crops and all feeding rates due to the increased rotational speed of the dust exhaust fan. The percentage of blown seeds also increased from 1.07% to 1.73% by increasing the speed of the cylinder from 350 to 500 rpm for the Faba bean crop, at a feeding rate of 720 kg / h. Consumed energy increased with the increase in moisture content, and knife speed. The results also indicated that a decreasing in the costs (LE/Mg) Productivity increased by increasing the feed rate. | ||||
| Keywords | ||||
| Development; Faba bean; Threshing | ||||
| References | ||||
|
Abd El Mowla, M.A.; M.H. Dahab; F.A. El Mahie and F.E. Abdallah (2014). Improvement and performance evaluation of stationary combine thresher. International Journal of Engineering & Scientific Research. 2(11): 40-51.
Abo Elnaga, M.A. (1995).Mechanization of balady bean crop in small holding under Egyptian conditions M.Sc. Thesis, Fac. Agric., Zagazig Univ., Egypt.
Ajav, E.A. and B.A. Adejumo (2005). Performance evaluation of an okra thresher. Agr. Eng. International: the CIGR Journal. Manuscript PM 04006 Vol. VII. October.
Al-Shamiry, F.M.S. and N.M.A. Yahya (2020). The performance evaluating of thresher machine attached to the tractor. IJRDO - Journal of Agriculture and Research. ISSN: 2455-7668. 6(3): 7-16.
Anwar, M. T. and C. P. Gupta (1990).Performance evaluation of chick pea thresher in Pakistan. AMA, 21 (3) : 23 – 28.
Desai, B.B. (2004). Seeds Handbook: Biology, production, processing and storage, Ed 2nd, Marcel Dekker Inc., New York, USA, 184- 185.
El-Behiry, A.A.; M.I. ward and A.M. El-Sherbieny (1997). Performance evaluation of some Wheat thresher machines under different conditions. Misr J. Ag. Eng., 14(4): 149-160.
El-Fakhrany, W. B. and M. A. Aboegela (2021) Manufacture and Development of a Small Threshing Machine. J. of Soil Sciences and Agricultural Engineering, Mansoura Univ., Vol. 12(3):117-122.
El-Nakib, A. A; Z. Y. Abdel-Lateef, A. A. El-Messery and A.Khattab (2003). Mechanical harvesting losses in rice crop using combine harvester. Misr J. Ag. Eng., 20 (4): 889-907.
Embabie, A.T. (1985). A comparison of different mechanization systems for cereal crop production. Unpub. M.Sc. Thesis. Agr. Eng. Dept.; Fac. of Agr., Cairo Univ., Egypt.
Hunt, D. (1983). Farm power and machinery management. 8th Edition, Iowa state Univ., Ames, U.S.A.
Kepner, R. A; K. Bainer and E. L. Barger (1978): Principles of farm machinery. AVI Publishing Company Inc., Westport.
Ismail, Z.E.; M.M. Ibrahim and S.A. Embaby (2009). Economic evaluation and selection of farm machinery. Misr J. Ag. Eng., 26(4): 746-757
Ministry of Agriculture and Land Reclamation (2012). Cropping area and production of winter crops (2002-2001), No. (5-3), Cairo, Egypt.
Main Department of Agricultural Economics (G.M.A.S) 2016 Agricultural Estimates and Issues (2015) Ministry of Agriculture and Salah El-Ghair. The Egyptian Arabic Republic . in Arabic.
Mohamed; E.M.N., (2001).The Effect of the engineering parameters of the threshers on the seeds quality in different cereal crops, M. Sc. Degree, Agic.Eng. Dep. - Faculty of Agic, Zagazig Univ.
Muna, N.H.; U.S. Muhammed; A.M. El-Okene and M. Isiaka (2016).Perfomance evaluation of a modified I.A.R. multicrop thresher. International Journal of Scientific & Engineering Research. ISSN 2229-5518. 7(11):1107-1116.
Nada; A. A.-H., (1994). Comparative study on locally manufactured, threshing machines for different crops, M. Sc. Degree, Agic. Eng. Dep. – Faculty of Agri, ZagazigUinv.
Pandey, A. and R.M. Stevens (2016). Performance evaluation of high capacity multi crop thresher on ‘gram’ crop. International Journal of Agricultural Engineering, 9(1): 94-101.
Shahbandeh, M. (2021). Wheat-statistics & facts (Mar. 23, 2021) - The Statistics Portal. [online] Statista. Available at: [Accessed 20 April 2021].
Singh, A.K., N. Chandra, R.C. Bharati and S.K. Dimree (2010). Effect of seed size and seeding depth on faba bean (Viciafaba L.) productivity. Environ. Ecology, 28:522-1527.
Vejasit, A. and V. M. Salokhe (2004). Studies on machine-crop parameters of an axial flow thresher for threshing soybean. Agriculture Engineering International: the GIGR Journal of Scientific Research and Development. Manuscript PM 04 004. | ||||
|
Statistics Article View: 159 PDF Download: 135 |
||||
