EVALUATION OF THERMOCYCLING EFFECT ON SHEAR BOND STERNGTH OF ORTHODONTIC MOLAR TUBE BONDED WITH TWO DIFFERENT ADHESIVE SYSTEMS (Electron microscopic study) | ||||
| Al-Azhar Journal of Dental Science | ||||
| Volume 26, Issue 4, October 2023, Page 555-561 PDF (750.36 K) | ||||
| Document Type: Original Article | ||||
| DOI: 10.21608/ajdsm.2023.200939.1428 | ||||
 View on SCiNiTO | ||||
| Authors | ||||
Shereen Aly Mahalawy   1; Ghada Al karanfilly2; Mona Dahab3
| ||||
| 1Lecturer of orthodontics,Department of orthodontics,faculty of oral and dental medicine,fayoum University | ||||
| 2Lecturer of biomaterials,faculty of oral and dental medicine, fayoum University | ||||
| 3Lecturer of oral biology ,Faculty of oral and dental medicine, fayoum unofficial | ||||
| Abstract | ||||
| Objectives: this study aimed to evaluate the thermocycling effect on shear bond strength of two different adhesive systems. Materials and Methods: The study was performed on 60 extracted human molar teeth, randomly divided into two equal groups. In Group I, conventional light cure adhesive system was used for bonding molar tube. While, Group II was bonded with single component adhesive system. Specimens from each group were thermocycled between 5 and 55oC for 1000 cycles. Teeth in all groups were deboned using a universal testing machine. Student's t- test was used to compare the shear bond strength between the groups. Scanning electron microscope was used to evaluate the depth of resin tag penetration. Results: The mean shear bond strength of group I was (15.9 +/- 3.4 Mpa) and that for group II was (13.1 +/- 3.9 Mpa).There was a statistically significant difference between the two groups (p= 0.04).The result of student's t- test comparisons of shear bond strength of group I and II following thermocycling indicated that there was a statistically significant difference where (p= 0.02), (p= 0.01) respectively. The comparison of resin tag penetration showed that there was a statistically significant difference between the two groups (p= 0.0003). Conclusion: Conventional adhesive group had a significantly higher mean shear bond strength than single component adhesive group. The mean shear bond strength value was significantly decreased following thermocycling at both adhesives. The depth of resin tag penetration at conventional adhesive group was higher than the single component adhesive group. | ||||
| Keywords | ||||
| Thermocycling; Shear bond strength; Molar tube; Adhesive system | ||||
|
Statistics Article View: 82 PDF Download: 105 |
||||
