ANALYSIS OF CUTTING FORCES IN MICRO MILLING | ||||
| The International Conference on Applied Mechanics and Mechanical Engineering | ||||
| Article 60, Volume 18, 18th International Conference on Applied Mechanics and Mechanical Engineering., April 2018, Page 1-18 PDF (1.76 MB) | ||||
| Document Type: Original Article | ||||
| DOI: 10.21608/amme.2018.35004 | ||||
 View on SCiNiTO | ||||
| Authors | ||||
| S. Mekhiel; A. Youssef; Y. Elshaer | ||||
| Egyptian Armed Forces. | ||||
| Abstract | ||||
| ABSTRACT In metal cutting, the prediction of cutting forces has been the focus of research for very long time. The reason for that is to decrease the cost of performing experimental work whenever the cutting of new material is needed. In recent years a new application for metal cutting was introduced due to the miniaturization of components and the invention of micro electro-mechanical system MEMS. This has led to the introduction of micro machining. Thus the analysis of the cutting system needed revisions. This is because of the domination of other factors during cutting process. Among these factors are the minimum chip thickness and the ploughing forces. In this work the modeling of orthogonal, oblique and milling cutting process in micro scale is presented. The results are verified using published experimental results. | ||||
| Keywords | ||||
| cutting forces; micro milling; analytical modeling; face milling and helical end milling | ||||
|
Statistics Article View: 194 PDF Download: 324 |
||||
