Influence of Pipe Diameter and Material on Water Hammer in Piped Systems | ||||
Journal of Advanced Engineering Trends | ||||
Volume 43, Issue 2, June 2024, Page 117-124 PDF (835.89 K) | ||||
Document Type: Original Article | ||||
DOI: 10.21608/jaet.2022.165688.1228 | ||||
![]() | ||||
Authors | ||||
Ahmed Khaled Abdella Ahmed ![]() ![]() | ||||
1Civil Engineering Department, Faculty of Engineering, Sohag University, Sohag, Egypt, | ||||
2Higher Institute of Engineering and Technology - Sohag, Egypt. | ||||
3Civil Engineering Department, Faculty of Engineering, Sohag University, Egypt. | ||||
Abstract | ||||
A sudden change in the pipeline's velocity results in a transient flow known as a "water hammer" in pipes. This phenomenon can cause negative and positive pressure in the pipeline and is often dangerous where the pipe can burst if the pressure is high enough. Therefore, it is necessary to study the variables affecting the water hammer to have a clear understanding of the controlling conditions of the water hammer, which could save the system from failures. This paper investigates the effects of pipe material and diameter on water hammer pressure. Three different pipe materials were examined (Steel, Concrete, and Polyvinyl chloride (PVC)) with different inner diameters (250, 350, and 500 mm). Numerical modeling and analysis are conducted to obtain the minimum and maximum pressure envelopes across the system of pipes. The numerical results obtained from the transient solver show that the normalized piezometric pressure calculated in different statuses directly changes with the change of the pipe material and diameter. The water hammer pressure has reduced significantly in pipe materials with less elastic modulus and larger diameter for the same operating condition. | ||||
Keywords | ||||
Piped system; Water hammer; Serge pressure; Pipe material; Pipeline simulation | ||||
Supplementary Files
|
||||
Statistics Article View: 91 PDF Download: 67 |
||||