SILVER TOUGHENED ALUMINA CUTTING TOOL INSERTS: PERFORMANCE EVALUATION USING DYNAMIC COMPONENTS OF CUTTING FORCE SPECTRA
K., D., A., G., K., R. (2008). SILVER TOUGHENED ALUMINA CUTTING TOOL INSERTS: PERFORMANCE EVALUATION USING DYNAMIC COMPONENTS OF CUTTING FORCE SPECTRA. EKB Journal Management System, 13(13th International Conference on Applied Mechanics and Mechanical Engineering.), 35-47. doi: 10.21608/amme.2008.39064
DUTTA A. K.; GUHA A.; RAY K. K.. "SILVER TOUGHENED ALUMINA CUTTING TOOL INSERTS: PERFORMANCE EVALUATION USING DYNAMIC COMPONENTS OF CUTTING FORCE SPECTRA". EKB Journal Management System, 13, 13th International Conference on Applied Mechanics and Mechanical Engineering., 2008, 35-47. doi: 10.21608/amme.2008.39064
K., D., A., G., K., R. (2008). 'SILVER TOUGHENED ALUMINA CUTTING TOOL INSERTS: PERFORMANCE EVALUATION USING DYNAMIC COMPONENTS OF CUTTING FORCE SPECTRA', EKB Journal Management System, 13(13th International Conference on Applied Mechanics and Mechanical Engineering.), pp. 35-47. doi: 10.21608/amme.2008.39064
K., D., A., G., K., R. SILVER TOUGHENED ALUMINA CUTTING TOOL INSERTS: PERFORMANCE EVALUATION USING DYNAMIC COMPONENTS OF CUTTING FORCE SPECTRA. EKB Journal Management System, 2008; 13(13th International Conference on Applied Mechanics and Mechanical Engineering.): 35-47. doi: 10.21608/amme.2008.39064

SILVER TOUGHENED ALUMINA CUTTING TOOL INSERTS: PERFORMANCE EVALUATION USING DYNAMIC COMPONENTS OF CUTTING FORCE SPECTRA

The International Conference on Applied Mechanics and Mechanical Engineering
Article 32, Volume 13, 13th International Conference on Applied Mechanics and Mechanical Engineering., May 2008, Page 35-47  XML PDF (1.02 MB)
Document Type: Original Article
DOI: 10.21608/amme.2008.39064
View on SCiNiTO View on SCiNiTO
Authors
DUTTA A. K.1; GUHA A.2; RAY K. K.3
1Professor, Dept. of Mechanical Engineering, Bengal Engineering and Science University, Howrah, India.
2Lecturer, Mechanical Engineering, Bengal Engineering and Science University, Howrah, India.
3Professor, Dept of Metallurgical & Materials Engineering, Indian Institute of Technology, Kharagpur, India.
Abstract
ABSTRACT
Cutting tool inserts have been fabricated using alumina with different amounts of silver
by conventional powder metallurgical route. The machining performance of these
composite inserts vis-à-vis that of commercial zirconia toughened alumina inserts have
been evaluated by dry turning operations on steel bars under a wide range of cutting
parameters. The experiments consisted of measurement and examinations of the static
and the dynamic components of the cutting force spectra, flank wear of the tool, surface
roughness on the work piece, and chip morphology. Analyses of the fluctuations in the
dynamic force spectra using a new approach based on a quasi-fractal model have been
used to reveal the potential of different tool materials with respect to their cutting
performance. Examinations and pertinent discussion of the operative wear mechanisms
during machining by the developed composites vis-à-vis their structure-property
relations are some essential supplements of this investigation.
Keywords
Alumina-silver Composite; Toughness; Machining Performance; Flank wear; Dynamic force
Statistics
Article View: 160
PDF Download: 224